What to do if your oil pump does not turn on?

What to do if your oil pump does not turn on?

If the pump does turn on but you do not get any or very much oil, there is a filter on the back side of the oil tank in the boat, make sure that it is still clean and will flow good oil. Then inspect the lines from tank to tank, and make sure that there are no kinks in any lines.

Why is my oil not transferring to the main tank?

Non-transfer of oil to the engine-mounted main tank can be as simple a problem as a neglected filter. Moisture gets into the remote tank from spray, rain, condensation, or from being located in the bilge where it can be splashed or submerged.

What to do if there is no oil in the tank?

Placed a long screwdriver in the tank and found oil in the bottom of the tank. Had the same problem last year. At that time, I added oil to the correct level on the dip stick, started it and later found the oil level to be too high. Drained some out and did not have a problem for the rest of the season.

Why is there no oil in my Harley Davidson tank?

Drained some out and did not have a problem for the rest of the season. I recently removed the plugs, turned over the engine to try to push the oil back into the tank, no luck. The oil light is off and no oil leaked out while the bike was sitting.

If the pump does turn on but you do not get any or very much oil, there is a filter on the back side of the oil tank in the boat, make sure that it is still clean and will flow good oil. Then inspect the lines from tank to tank, and make sure that there are no kinks in any lines.

Non-transfer of oil to the engine-mounted main tank can be as simple a problem as a neglected filter. Moisture gets into the remote tank from spray, rain, condensation, or from being located in the bilge where it can be splashed or submerged.

What to do when your oil tank is low?

Leave oil tank empty until low oil warning has been tested. Turn key switch to ON. SystemCheck gauge should initiate a test mode, momentarily sound the warning horn, and illuminate all four indicator lights. The “LOW OIL” light should remain illuminated. Next fill the oil tank with oil and install the oil fill cap.

How does the oil transfer from the auxiliary tank work?

As long as the remote tank contains enough oil, a green LCD lights up on the tachometer and the electric pump will transfer oil to the engine as needed. In the main tank, as oil is consumed and the level drops, a float triggers the middle switch (SW 2), which informs the control unit to turn on the electric transfer pump.