Are there turn signal lights that do not blink?
Hi, it happened last night in the middle of a ride. turn signal lights come on but do not blink on and off (only left turn signal, the right one blinks just fine). at the front, the amber light stays on solid, without blinking. At the back, it doesn’t blink, and the integrated LED light stays amber also.
Why are my left side turn signal lights not working?
If the wiring and switch gear is intact and working, and if the flasher unit is working for the right side, it should for the left too. That leaves the left side turn signal LEDs as the most likely problem.
How can I tell if my turn signal has burned out?
Assuming that the OP has load resistors on his LED turn signals, the logical place to start is to check to see if the load resistor for the left-hand turn signals has burned out. Take the load resistor out of the circuit and place the leads of an ohm-meter across the load resistor to measure the resistance.
How can I Test my Turn signal light?
Even if you don’t have a volt-ohm meter, one easy test is to take a standard 1156 or 3156 bulb, connect one contact to the hot wire feeding your left signal, and connect the other contact to the bike’s ground.
Why are my turn signal lights not working?
First, I’d make sure your rear turn signals are connected properly. Can’t think of another reason ATM why LEDs wouldn’t be lighting for you in such a system. However, what’s likely causing both sides to light is insufficient resistance in the system, since LEDs use so much less power than the OEM incandescent bulbs.
What to do if your turn signal lights are flashing?
It should fix the problem you have. EDIT: use the new blinker relay with LEDs and install the lights back to their fully installed normal configuration. Then install the diode. If the cluster light were coming on and all four blinkers were flashing, I’d say it’s definitely diode issue.
How to stop turn signal lights from acting like hazard lights?
-Put back in the OEM blinkers, if you have them, with OEM relay (just connect, no need to do complete install) to see if things work properly once returned to stock. Posts: A lot. The instrument cluster light is causing you problems. You need a diode to prevent it from doing exactly what you are seeing.
Are there white bars under the seat on a Kawasaki Ninja?
Couple of things: there’s only one flasher relay on the ninja250, and most vehicles for that matter. Unless Kawasaki changed something between the ’08 and ’09 (haven’t found anything but color and some damper patterns yet) there aren’t any ‘white bars’ under the seat, stock.