What to do with Kawasaki zg1200 Voyager XII?
Kawasaki ZG1200 Voyager XII: video. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later.
What are the specs of a Kawasaki Voyager XII?
Kawasaki ZG1200 Voyager XII: specs. Kawasaki ZG1200 Voyager XII: images, gallery. Kawasaki ZG1200 Voyager XII: video. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
How do you change the oil on an AVA Voyager?
There are two ways to go about changing the oil. The easy way is to drain out the old oil from the plug at the bottom of the fork. Remove the wheel and pump the lower fork tube up and down until no more oil comes out. When changing the oil, the shop manual says replace it with 330mL of new oil.
Where are the exhaust bolts on an AVA Voyager?
1. Put bike on center stand. 2. Disconnect wiring connectors then remove saddlebags. 3. Remove two bolts for the exhaust for each side. Bolts are under the rear floorboards and aft. 4. Loosen the bolts to the exhaust just forward of the crossover tube for the mufflers. One on each side. 5.
How do you drain fuel tank on Ava Voyager XII?
So, one of the most important things you should do is drain the carbs. Start by turning off the fuel tank petcock (if you have one, Voyager XII’s do not). Then, located in the float bowl of each carb is a small Phillips screw or bolt, these are usually angled to the side.
What to do with a new AVA Voyager filter?
Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant. Don’t forget to the reinstall white plastic ladder looking holders. The cost at our local Advanced Auto Parts was under $5.
What should the tire pressure be on a Voyager?
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.
What kind of lubricant do you use on Kawasaki Ava Voyager?
Do not use gasoline, motor oil, or any other petroleum distillate, as this will cause deterioration of the rubber parts. When lubricating these shafts, Kawasaki recommends using a Poly Butyl Cuprysil grease (PBC is a special high temperature, water resistant grease).