How do you turn off the alarm on a Harley Davidson?
With an assigned fob present, turn the OFF/RUN switch to OFF. Turn the ignition switch to IGN. Cycle the OFF/RUN switch twice: RUN – OFF – RUN – OFF – RUN. Press left turn signal switch 2 times. ENTER PIN will scroll through the odometer window. Press right turn signal switch 1 time and release. Turn signals will flash 3 times.
How to disarm the Smart Security system on a Harley Davidson?
Also, with the battery disconnected in the fob I can keep the fob in one of the bike’s bags without worrying that it’s deactivated the alarm should someone get any ideas of rolling away with it. Every once in a while I use the PIN to disarm the system to help me remember what the PIN is.
When do the warning lights come on on a Harley Davidson?
Unfortunately, you can drive your brand new Harley off the lot and not get five miles down the road before a warning light comes on. Or, you could be a thousand miles from home when they start flashing. What do they mean?
How can I start my Harley Davidson without a key fob?
Unless you know how to override your Harley Davidson security system by a sequence of things you can to enter your security PIN code, which includes ignition switches, signal switches, and Run/Off switches. Ultimately, this will allow you to start your Harley Davidson without the key fob present and ride on!
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
Why do the lights keep flashing on my Harley Davidson?
It’s when the fob is out of range and the bike is “disturbed” a bit and the security activates by flashing the lights like it is supposed to do but the dang lights just keep flashing till I get my fob out of the house and take it close to the bike. Have you tried to turn off the security system and turn it back on.
Why does my security system keep flashing lights?
It was explained to me that a slight bump/jiggle would make the security system flash my lights just a little but a significant bump/jostling would make the lights flash maybe 2 minutes.
How do you reset the turn signal on a Dyna Glide?
Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.