What should the AC voltage be on a Honda stator?
It should run with a good battery and the rectifier disconnected. With it running and rectifier disconnected there should be an AC voltage on all 3 phases ( Yellow Wires). Probably around 30 volts with the engine reved up to the 5000 RPM the charging system is speced at. The rectifier needs good ground to charge.
How can I tell if my stator connector is defective?
Ohms Test. You will need a multimeter set to Ohms for this test. Test every lead of the stator’s connector and note the readings. The reading of each combination should be the same (test leads 1-2, 2-3, and 3-1). If they are different, your stator is defective.
Where is the voltage rectifier on a Honda?
There is a good possibility that the voltage rectifier is the problem or related wiring. The rectifier is found attached to the frame just above the right rear tire, Try unplugging the rectifier and testing wires. The red wire should have battery voltage all the time.
What should I do if I get a reading on my stator?
Set your multimeter to Ohms. Put the negative lead on the engine’s ground and the positive lead on each wires of the stator’s connector one by one. You shouldn’t get a reading at all. If you get a reading, even very small, on any wire, the stator is defective and must be changed. Put your multimeter to AC Volts and start you vehicle.
Set your multimeter to Ohms. Put the negative lead on the engine’s ground and the positive lead on each wires of the stator’s connector one by one. You shouldn’t get a reading at all. If you get a reading, even very small, on any wire, the stator is defective and must be changed. Put your multimeter to AC Volts and start you vehicle.
Ohms Test. You will need a multimeter set to Ohms for this test. Test every lead of the stator’s connector and note the readings. The reading of each combination should be the same (test leads 1-2, 2-3, and 3-1). If they are different, your stator is defective.
What should static voltage be on Honda ATV?
The reading should be between 12.5 volts and 13 volts. If the reading is below that, the battery should be charged and the static voltage test repeated. If the reading is still below 12.5 volts, the battery needs to be replaced.
How do you test Honda ATV charging system?
Insert a pair of back probes against the red wire and the yellow wire at the wire connector on the regulator/rectifier unit. Connect the probes to a multimeter and set the meter to AC volts, then start the engine and let it idle.