Can you put pin lock on Mighty Mule slide gates?
Yes. However, to avoid theft, add the Mighty Mule Pin Lock accessory on the front end of the swing gate operator to ensure that only the homeowner can unlock and release the opener. For adding pin locks to slide gates and for more details contact Mighty Mule customer service at 800-543-4283.
How tall is a Mighty Mule automatic gate operator?
Can I open my Mighty Mule automatic gate operator from my house with my Mighty Mule transmitter? The normal operating range of the Mighty Mule entry transmitter is 50 ft. to 100 ft. However, because it uses a radio frequency and is subject to interference by weather conditions, topography, outside interference, etc., the actual range may vary.
What causes a mighty mule gate to malfunction?
Mighty Mule’s Automatic Gate Openers are currently in use from the Arctic to the Amazon. Because of the battery’s design, extreme cold may cause it to operate a little slower than under normal conditions, and may cause it to malfunction.
Can a Mighty Mule transmitter be personalized?
No, not if you personalize your transmitter code. Every Mighty Mule entry transmitter comes with identical factory settings, but you can personalize your code by repositioning the dip switches inside the Mighty Mule entry transmitter. Please review your installation manual for additional programming information.
What’s the average speed of a Kawasaki MULE?
The Mule Will Only Run 22 Mph Per The Gps. I Very Seldom Run It Full Throttle, If At All, But Would Like To Know I Had Plenty Of Speed If I Needed It. Click to expand…
What should I do about my mule Governor?
If you run correct and clean oils, keep the valves adjusted, do not let the clutches get out of tolerance, run a belt that is within the specified tolerances, and never exceed the maximum designed engine red line, it should be fine. But, that is what I was doing too!
How to tune up a Kawasaki MULE Governor?
I USUALLY TUNE UP AND ADJUST (IF NEEDED) ALL MY TOYS, BUT IM STUMPED ON THIS ONE. Click to expand… Danny you have an entirely different mule than a 610 aircooled single cylinder engine. Just leave the govner stock and the 4000 Mule will last longer.
What’s the average speed of a mule Governor?
But, that is what I was doing too! My 610 was making 23MPH on GPS, I modified the governor and got it doing 31 MPH, maybe with a little more modification it may have even gotten a mile or so more.