Are power commanders interchangeable?
No. The connectors are different for each injection system on each bike. In theory you can snip the old connectors off and wire up new ones.
Do power commanders go bad?
Power Commanders can go bad, like any electronics. The quick test is to bring your revs up to 2,500 rpm using your fast idle lever, then pull in the clutch. The revs should drop about 500 rpm.
How to install power commander on a Harley Davidson Road King?
How to Install Power Commander to a Harley Davidson Road King Step 1. Remove the right-side frame cover to access the Electronic Control Module (ECM). Remove the ECM by unscrewing… Step 2. Unplug the ECM from the motorcycle’s wiring harness. Plug the black connector from the Power Commander …
Can a Dynojet power commander connect to a computer?
For tuning, our Power Commander is a truly powerful device, but its tracking and monitoring is what truly sets it apart. It easily connects to any computer through USB and has a -100/+250% fuel change range for more adjustment possibilities.
What kind of motor does a Harley Davidson Road King have?
Harley-Davidson’s Road King series has set a high level of standards. Built for the long haul, the Road King V-twin motor has a comfortable seat, windshield and hard saddlebags. To enhance the King’s performance, a Power Commander electronic fuel-injection controller can be installed easily to fine-tune the bike’s power delivery.
Where is the power commander on a Harley Davidson Twin Cam 88?
1. Remove the seat. 2. Remove the left and right side covers. 3. From the left side of the bike route the Power Commander III cable over the frame rail and under the stock wiring harness in the area of the section of the seat. Make sure the seat does not put pressure on the Power Commander III cable. 4.
For tuning, our Power Commander is a truly powerful device, but its tracking and monitoring is what truly sets it apart. It easily connects to any computer through USB and has a -100/+250% fuel change range for more adjustment possibilities.
How do you adjust the power commander on a Harley Davidson?
Adjusting Your Power Commander Your Power Commander has been programmed with a base map for your application. You can adjust the base map or install an alternate map using your Computer. Please refer to the supplied CD-Rom for more information. You can also adjust your Power Commander using the face plate buttons as described below. 1.
1. Remove the seat. 2. Remove the left and right side covers. 3. From the left side of the bike route the Power Commander III cable over the frame rail and under the stock wiring harness in the area of the section of the seat. Make sure the seat does not put pressure on the Power Commander III cable. 4.
How does the power commander fuel tuner work?
With tracking, tuning, and monitoring capability, this fuel tuner can easily and effectively optimize your air/fuel ratio without directly changing the ECU. This makes it super easy to revert back to stock options whenever you need to. Our Power Commander tuning device is a powerful device that can completely overhaul your driving experience.