What kind of carburetor does a 150cc GY6 use?
The fuel also has to be atomized as much as possible (i.e. be supplied in tiny droplets). The carburetor controls all these functions and generally does it quite well. The type of carburetor used on most 150cc GY6 type engines is a Keihin style CV carburetor with a 24mm throat.
How to tune a GY6 Chinese scooter 150 or?
Tuning a GY6 carburetor in a chinese scooter. This procedure works with most chinese scooters, 50cc, 125cc, and 150cc. Loading…
Where is the carburetor on a Chinese scooter?
Above is a picture of a typical GY6 engine carburetor and the view is that from the right side of most engine configurations on 150cc Chinese scooters. There’s a small spring loaded screw which adjusts the idle speed. It’s right next to the throttle control which is connected to the twist grip on the right handlebar.
Can a carburetor go out of Adjustment on a scooter?
If there’s any one component that’s more likely to go out of adjustment on your scooter (especially perhaps your Chinese scooter!), it’s the carburetor. If it does go out of adjustment lots of things can happen.
How long should the needle be on a GY6 carburetor?
Now connect the choke’s electrical leads to a 12v power source. Black is negative. Wait 5-10 minutes and re-measure. The needle should have extended. The overall length should be approximately 3mm more than before. Tags: GY6 Carburetor
Why does my GY6 engine choke not work?
To the auto choke’s credit, usually problems starting and running on a GY6 engine are related to dirty carburetor jets, but the auto choke system can be to blame sometimes as well. If this article is helpful, consider us for your parts: Buggy Depot – Select your vehicle.
Where is the needle on a carburetor choke?
Remove choke assembly from the choke holder on the side of the carburetor. The needle should be clearly visible. Measure the overall length of the choke from end-to-end, including the very tip of the needle. Now connect the choke’s electrical leads to a 12v power source. Black is negative. Wait 5-10 minutes and re-measure.
Where is the power source on a choke buggy?
Remove choke assembly from the choke holder on the side of the carburetor. The needle should be clearly visible. Measure the overall length of the choke from end-to-end, including the very tip of the needle. Now connect the choke’s electrical leads to a 12v power source. Black is negative.