Can a bad ground cause no spark on a motorcycle?

Can a bad ground cause no spark on a motorcycle?

Bad grounds can cause no spark issues though. It can cause the ground to ground through the ecu frying it. If you get a single spark when turning on the ignition then nothing when cranking it’s the ecu.

What If my ignition coil has power but no spark?

If the ignition coil does not have spark, it’s time to check its wires. Use a test light to check the continuity on the signal wire and power wire on the ignition coil. If both wires are functional but the coil fails to produce spark, the ignition coil or the ignition control module is bad.

Why is there no spark to my spark plugs?

There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started. Then a couple of days later it did the same thing, so spark.

Why does my Harley Davidson have no spark?

No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.

What to do when your engine has no spark?

Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.

Why does my 2006 heritage have no spark?

I have a 2006 Heritage. There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.

There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started. Then a couple of days later it did the same thing, so spark.

No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.

Where are the spark plugs on an EZGO?

There are two different coils, one for the spark plugs and one (pulser) that is behind the flywheel that controls the igniter. Is they power at the igniter? the secondary wires (Ref Fig. 3 on page M-5). A normal Secondary (A and B): 10.8 – 14.6KΩ. If readings coil. Unplug the connector leading into the engine. Place the

Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.