What is the Tssm?
Acronym. Definition. TSSM. Two-Spotted Spider Mite.
How to diagnose a Harley Davidson TSM / TSSM?
I {Heart} Hookers. To diagnose the TSM/TSSM observe the behavior of the turn signals. 2 Turn Ignition key On-Off-On-Off-On-Off-On and then toggle the Left Turn Signal switch twice. – – 3 Turn Ignition key Off-On Verify the Check Engine lamp and Security Lamp illuminate briefly and then turn off.
Where is the TSM / TSSM / hfsm located?
The TSM / TSSM / HFSM is located in the bottom of the battery tray. From under the rear fender and just in front of the rear tire, push the TSM / TSSM/ HFSM up through the battery tray. 6). Depress the two tangs on each side of the wiring connector and pull free from TSM / TSSM / HFSM. 7).
How to disable alarm and replace TSM / TSSM / hfsm?
Depress the two tangs on each side of the wiring connector and pull free from TSM / TSSM / HFSM. 7). Install wiring connector into new TSM / TSSM / HFSM and reinstall doing the reverse of the procedure listed above.
How to read a TSM / TSSM trouble code?
Current and Historic. If a trouble code is stored, it can be read using TSM/TSSM Diagnostics. Current trouble codes are those which are present during the current ignition cycle. problem is dropped and it becomes a historic code rather than a current code. Intermittent output shorts can become typical historic codes.
What is the TSSM code for a Harley Davidson?
If the siren responds with 3 chirps instead of 2 the siren battery is bad. Pin A (Bn/Gy) is positive voltage downstream of the 15amp security fuse. 34= Starter relay and coil are grounded via TSSM when disarmed and ignition on. Starter relay could be bad (voltage present on pin 9) (Tn/Gn) when not starting engine.
The TSM / TSSM / HFSM is located in the bottom of the battery tray. From under the rear fender and just in front of the rear tire, push the TSM / TSSM/ HFSM up through the battery tray. 6). Depress the two tangs on each side of the wiring connector and pull free from TSM / TSSM / HFSM. 7).
How to troubleshoot an ICM error code on a Harley?
Speedometer Self Diagnostics: The speedometer is capable of displaying and clearing speedometer, tachometer, TSM/TSSM and ICM/ECM Diagnostic Trouble Codes (DTC). Turn Ignition switch to OFF & Run/Stop switch is to Run. Push odometer reset button in & hold. Turn ignition switch to Ignition and release the odometer reset button.
What is the trouble code for a TSSM siren?
25= should be no voltage present on pin 10 with key off. (Lt Grn/Gy wire on TSSM) 31&32= Middle pin on siren goes low voltage to fire alarm, high voltage to stop. If the siren responds with 3 chirps instead of 2 the siren battery is bad. Pin A (Bn/Gy) is positive voltage downstream of the 15amp security fuse.