Why is my starter not working on my Harley Davidson?
Here’s a Harley Davidson starter issue that can have a simple solution. We talked about the electrical circuits on our motorcycles and this is a good example of how the mechanical component might not be working even if the electrical component is. The starter sprag clutch is an easy fix and we show you how it’s done.
How long does it take to replace a Softail starter?
02 Softail Deuce Starter Replacement in under 7 minutes. – YouTube You are supposed to get the oil tank off without removing the rear tire but I was going to replace a valve stem too. that is in a separate video.
How do you replace a starter on a Harley Davidson?
Add a drop of blue Loctite to the threads of the starter mounting bolts. Insert the bolts into the starter and thread into the inner primary. Torque bolts to 25-27 foot-pounds. Remove cloth and reinstall oil filler cap. Slip battery positive cable ring over stud and install nut.
How can I swap out my starter motor?
The starter motor and is very easy to swap out. First, disconnect your battery. Do not skip this step. Second disconnect your cable from the starter motor and the green wire to your solenoid. Third, remove your primary cover (follow the step-by-step instructions in your manual) Fourth, remove the compensating sprocket nut and clutch hub lock ring.
What are the symptoms of a Harley Davidson starter problem?
Harley Davidson Electra-Glide 1985 FLHT start clutch drive problem. Symptoms: When starter button is pressed there is a click and nothing happens or the starter drive tries to engage and then does not stay engaged. There is a lot of racket and noise like gears grinding.
What’s the top speed of a Harley Davidson Fat Boy?
MCycle mentions that the bike has a top speed of 91.96 MPH and that it weighs 657 lbs. The Fat Boy is perhaps the most car-like of any Bike that we can think of. The suspension is so good you could probably ride directly over an open manhole and never notice.
Add a drop of blue Loctite to the threads of the starter mounting bolts. Insert the bolts into the starter and thread into the inner primary. Torque bolts to 25-27 foot-pounds. Remove cloth and reinstall oil filler cap. Slip battery positive cable ring over stud and install nut.
What should I do if my starter doesn’t work?
Replace the starter drive unit, as well as the plunger unit. Clean and tighten all solenoid, starter and battery connections. Make sure the primary starter bushing isn’t work as well. Just did this on my ’08 Ultra. With the SE compensator, and AllBalls starter drive, it fires up better then it did when brand new!
The starter did push through it but after about 1/2 of a revolution, the engine kicked back as if the timing was too advanced. That caused the starter pinion to kick out of the ring gear which resulted in the starter grinding. I then released my finger from the start button. Pushed it again and it started correctly.
What does hard starting on a Harley Davidson mean?
If hard starting was engine barely or doesn’t turn over, it would mean two things, your battery should be back up to full and with surface charge reserve of 14V (2 volts over full charge 12.6 or so) so battery “should” not be an issue IF charging ckt and connections are sound.
What causes a Harley Davidson to not turn over?
If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.
What should I do if my starter motor is out?
Like he said, most likely is your battery. However, when the hold in coil is out on the starter solenoid it will do the same thing that you are just describing. In that case you need a new starter motor or you could try to rebuild your solenoid. The starter motor and is very easy to swap out. First, disconnect your battery. Do not skip this step.
What are the problems with a Harley Davidson starter?
Harley Davidson Common Starter Problems Summary and Fixes – YouTube There are a few very common HD Starter problems. It starts with pushing the start button on only hearing a There are a few very common HD Starter problems. It starts with pushing the start button on only hearing a Skip navigation Sign in Search Loading…
What should I do if my fuel injected Harley wont start?
On fuel injected models, make sure that you can hear the fuel pump cycle when switched to RUN. If not, check your fuses. As always, the best way to avoid being stranded with your Harley Davidson is to be diligent about your bike’s maintenance.
What makes a Harley Dyan engine difficult to start?
Okay, so if your Harley Dyan motorcycle is older than 2005, and the engine is difficult to start, check for one OR MORE of the following possible malfunctions. 1. Fouled spark plug (s). 2. Improperly adjusted enricher valve. 3. Intake manifold air leak. 4. A plugged fuel tank filler cap. 5. Clogged carburetor fuel line. 6. Contaminated fuel system.
What to do when your motorbike wont start?
Look up direct start button cover. It can get you out of a jam when the solenoid acts up. Won’t help if the battery is to low to crank the engine though. Was this answer helpful? I dont own a motorbike.