What to do if your Acura dome light wont turn on?
Using a spark tester, ground the tool and push the prongs into the dome light fuse. If it does not read any power, pull it out and give it another visual inspection. Replace the fuse and test the lights. Figure 2. Normal vs. blown fuse. If your fuse did blow, there may be another issue occurring somewhere else on the harness.
How do you replace the brake line on an Acura TL?
At this point, and with the caliper off, the only thing attached to the caliper is the brake line. Use your wrench to remove the line nut, then remove the line and install it onto the new brake caliper. Install the caliper on top of the rotor, then tighten the two bolts on the back of it.
Where are the interior lights on an Acura?
Besides illuminating the cabin, they also act as a safeguard to warn you of whether or not a door is open. The lights are controlled by a panel found on the headliner of your car and protected by a dome fused located inside the fuse box.
What does it mean when the Acura brake light comes on?
Have an auto mechanic diagnose your Acura braking system. If this light comes on, it means there is low oil pressure in the engine. Stop the vehicle as soon as possible and check the oil level. Add oil if the level is too low.
Why is my VSA light not working on my Acura TL?
If you do opt to purchase a code scanner, just be aware that the cheaper ones will often only read the engine. That’s fine most of the time, but the problem causing the VSA light in your TL could be in one of the other control units.
What to do when your interior lights wont turn on?
Locate the interior fuse box and find the dome light fuse. Using a spark tester, ground the tool and push the prongs into the dome light fuse. If it does not read any power, pull it out and give it another visual inspection. Replace the fuse and test the lights.