How to reset belt light on 2003 kawasaki Prairie 360?
Here is a step by step procedure for reseting the belt light on a Prairie 360. Then, find the black and grey plugs up under the gas tank cover. These are on the clutch side, just above the belt snsor. Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently.
Can you reset the belt on a Kawasaki Prairie?
Learn how to reset your ATV belt check light yourself. The Kawasaki Prairie 360, Kawasaki Prairie 650, Kawasaki Prairie 700, Kawasaki KFX700 V-Force, Kawasaki Brute Force 650, and Kawasaki Brute Force 750 ATVs are fitted with drive belt alert systems.
Is there a belt Trip Switch on a Kawasaki 360?
This has been the case with many 360 owners, they found them after looking further. There is a procedure in the Vforce folder for the Vforce to reset the light. The Vforce does not have a belt trip switch. Note: Disconnecting the battery does not reset the light.
How do you reset the belt light on a prairie 360?
Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were. Don’t foget to fasten them back up to the frame, if you pulled the strap off of them. Cut the key on to verify the procedure worked.
Where are the plugs on a Kawasaki Prairie 360?
Then, find the black and grey plugs up under the gas tank cover. These are on the clutch side, just above the belt snsor. Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were.
Learn how to reset your ATV belt check light yourself. The Kawasaki Prairie 360, Kawasaki Prairie 650, Kawasaki Prairie 700, Kawasaki KFX700 V-Force, Kawasaki Brute Force 650, and Kawasaki Brute Force 750 ATVs are fitted with drive belt alert systems.
Then, find the black and grey plugs up under the gas tank cover. These are on the clutch side, just above the belt snsor. Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were.
Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were. Don’t foget to fasten them back up to the frame, if you pulled the strap off of them. Cut the key on to verify the procedure worked.
How do I check my belt on my Kawasaki ATV?
Models equipped with a Drive Belt Check system may alert you to check your belt by illuminating a light on the instrument cluster. Machines equipped with the Drive Belt Failure Detection System are put into a slowmode when the system is tripped.