Is there a problem with my Honda Rubicon?
Ok so lets say iam runing in D2 (which is auto high range) it will read D2 and if the RPM get to high a little hand will come up! It also will not shift! It has one gear that it is in all the time! (which is so god dam! low you cant do anything) You get one gear forward and revers! NOTHING ELSE HAPPENS!! Please help!
How often do you need to clear code on Honda Rubicon?
Clear them (remember the codes). You should have to do this 3 times to clear all nine codes if that many are present.
How to put esp on Honda 500 Rubicon?
1. Put the gear shift lever in neutral (be sure the neutral indicator comes on) and the ignition switch OFF (vehicle at a stop). 2. While pushing the UP and DOWN shift switches (ESP) simultaneously, turn the ignition key to the on position. 3.
Why is the speedometer on my Rubicon 500 not working?
I’ve got an 02 Rubicon 500 ES and I just got done replacing the digital readout screen (speedometer, gear position etc) because it was broken. The screen works now and it will go into forward and reverse but the electonic shift doesn’t work and the gear position just flashes on the screen.
1. Put the gear shift lever in neutral (be sure the neutral indicator comes on) and the ignition switch OFF (vehicle at a stop). 2. While pushing the UP and DOWN shift switches (ESP) simultaneously, turn the ignition key to the on position. 3.
What to do when Honda Rubicon wont shift?
Push and hold both the up and down shift button simultaniously. While doing this, turn the ignition on and immediately release both shift buttons. The press both shift buttons again for about 2 seconds. The display will not blink as before, but in a rythm. Count the flashes and this is the code being thrown.
I’ve got an 02 Rubicon 500 ES and I just got done replacing the digital readout screen (speedometer, gear position etc) because it was broken. The screen works now and it will go into forward and reverse but the electonic shift doesn’t work and the gear position just flashes on the screen.
How is the problem code displayed on a Honda Foreman?
4. The problem code is displayed by a certain number of blinks “ – – “ on the gear indicator, which indicates the problem code by the number of blinks. If “N” (neutral) stays ON on the position indicator, the retrieval process was not correctly performed.
What should the battery reading be on a Honda Rubicon?
You should get an 11-12 volt reading. If you don’t get this reading, replace the battery. Put the Rubicon into the neutral using the gearshift located on the side of the ATV. Hold the “Up” and the “Down” shift buttons down at the same time and then release them. Press both of the buttons down again and hold them for about two seconds.
How do you put a Honda Rubicon into neutral?
Put the Rubicon into the neutral using the gearshift located on the side of the ATV. Hold the “Up” and the “Down” shift buttons down at the same time and then release them. Press both of the buttons down again and hold them for about two seconds.
Why does my Honda Rubicon 500 go into limp mode?
This 4wheeler has been giving issue for 10 years. It would constantly go into limp mode. I would reset it. And go on. Over the years I have changed 3 angle sensors. Did this because of the code given. No help and yes I did preload. The symptoms are now that it often does not reset.