How to replace a Big Bear drive shaft?
there are going to be little circle clips holding the u-joint on, if you’re lucky it might all fall apart, or you might have to do some hammering on the centers of the u-joint itself to get it to move. heat is always good sometimes too if you’re careful, just a small propane torch for plumbling….
How to replace U-joints on Yamaha Big Bear?
You first locate the two bolts that hold the center bearing assembly to its cross brace and remove them. Then, you go to the rear differential and remove the two straps holding the rear u-joint to the pinion shaft. Once you remove the rear u-joint from the pinion shaft, tape the loose end caps in place to prevent loss.
How to replace front disc brake rotor Yamaha Big Bear?
Insert a steel rod into the front disc brake rotor and rotate clockwise to contact the front wheel knuckle, to prevent the front disc brake rotor from turning during front wheel driveshaft and joint installation. A new front axle wheel hub retaining nut must be installed.
What kind of bumper do I need for my Big Bear?
I only need a couple think from the machine. Front bumper is #1. The other is the front plastics in grey. Used is fine as long as there is no cracks. Recently bought my BB. Everything works great.
How to replace front wheel driveshaft on Yamaha Big Bear?
Separate the ball joint from the front wheel knuckle using a prybar. Position the end of the prybar outside of the bushing pocket to avoid damage to the bushing. Use care to prevent damage to the front wheel driveshaft joint boot.
How does a Big Bear drive shaft work?
Everything works great. Only thing is, each time I put it in reverse, it either starts to rev high and start moving without giving it gas or I’ll give it a bit of gas and let go and it will still rev at the same rpm or higher and keep moving. Doesn’t do it for high or low.
Where are the U-joints on a Yamaha Big Bear?
Has a double shaft with a bearing in the middle. Bearing has a square frame around it.Has 3 u-joints on the drive shaft. The shaft is removed in one piece. You first locate the two bolts that hold the center bearing assembly to its cross brace and remove them.
How to yoke a Yamaha Big Bear 350?
(Playback ID: G4J8knqt4SGXC_mE) An error occurred while retrieving sharing information. Please try again later.