Why does my motorcycle vibrate at high speeds?

Why does my motorcycle vibrate at high speeds?

A motorcycle that vibrates upon acceleration is usually caused by front or rear tire issues such as uneven tread, unbalanced tire, a bent rim, or a sticking brake caliper. Other reasons may include a bent front or rear sprocket, a sticking piston, a bad crankshaft bearing, or a cylinder misfire.

How do I stop my motorcycle engine from vibrating?

To reduce these vibrations, here are a few things you can do:

1. Olympia Anti-Vibe Gloves. Olympia 610 Anti-vibe Gloves are available in the market at an affordable price.
2. Fill Your Engine Oil.
3. Change Your Engine Oil.
4. Configuration of Disks and Brakes.
5. Valve tappets.
6. Changing your air filters.
7. Check up on your wheel chains.

Why does my Harley Davidson have a vibration problem?

I have a vibration problem that occurs when I release the throttle to slow down or come to a stop. At a certain rpm it vibrates so bad it sounds as if the fairing and tourpak are going to fall off. The vibration has already ruined the front motor mount which I replaced.

What to do if your Harley Davidson engine is making noise?

Look for the easy stuff, then on to the expensive. Check the front motor mount to make sure the elastomer has not broke from the metal. Make sure the link at the top of the engine, and front of the engine is attached at both ends. Jack the rear wheel off the ground and have someone hold the bike.

What’s the problem with a Harley Davidson Dyna?

This solution is commonly used especially with the most recent engines and it was successfully used on the historical FXRs that precede Dyna. The problem in Dyna is that this supports measure only 19 mm (¾”), therefore very thin compared to the old models, where they were fixed on the external sides of the frame.

What’s the spec on a 2007 Harley Davidson?

Have dealer check crank run out. harley knows there is a problem with 2007 flhx’s. harley just replaced mine. spec is .012. mine had .024. You can’t post conmments that contain an email address. An expert who has achieved level 1.

I have a vibration problem that occurs when I release the throttle to slow down or come to a stop. At a certain rpm it vibrates so bad it sounds as if the fairing and tourpak are going to fall off. The vibration has already ruined the front motor mount which I replaced.

What kind of vibration does an Indy bike have?

After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts. Took it to several shops, both HD and indy guy and none of them could figure it out. They did get it so the vibration only bad between 1300 to 2000 RPM’s, but still unbearable.

What kind of vibration does a 2000 Electra Glide have?

I had the same problem and here’s the story. My 2000 Electra Glide has a little over 50K miles on it. At about the 40K mile mark I replaced the front motor mount. After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts.

Why is the vibration on my Big Twins gone?

Vibration GONE!!! There have been a lot of threads over the years about big twins developing a serious vibration after changing the front motor mount. Many thought it was the new style mount and various other reasons. I had the same problem and here’s the story.