Is there a 1978 drag bike for sale?
I currently have a 1978 KZ 1395 Drag Bike for sale. This bike is all fresh wheel to wheel, carb to crank and ready for the drag strip. The frame has a clear title so I suppose you could get a tag if you wanted although good luck keeping your drivers license very long.
How big is the crank on a drag bike?
YFZ built by JSR last year, it has only been raced a few times. It has a 6 mil. ClawHammer crank, 98 mil. Bore, stage 2 cams and valves, port and polished head, over-ride transmission, new full bore plastic, 6-inch extended chrome swing arm, chrome drag axel, K&N air box.
How many horsepower does a clawhammer drag bike have?
ClawHammer crank, 98 mil. Bore, stage 2 cams and valves, port and polished head, over-ride transmission, new full bore plastic, 6-inch extended chrome swing arm, chrome drag axel, K&N air box. It has been Dyno tested at 60 horsepower, and it runs a consistent3.3 second 200-foot race.
What kind of engine does a nitro drag bike have?
Nostalgia nitro Harley drag bike 96 cu. s&s bottom end,venolia pistons, dyna stacked ign with new coils, frame oddities chassis modified by Grizzly Welding, baby B&J 2 speed transmission, extra new used 555 sifton cam set, new set of rods, starter cart and 15 gallons nitro turn key.
I currently have a 1978 KZ 1395 Drag Bike for sale. This bike is all fresh wheel to wheel, carb to crank and ready for the drag strip. The frame has a clear title so I suppose you could get a tag if you wanted although good luck keeping your drivers license very long.
What did the ch stand for on an Ironhead?
The XLCH was a sportier version of the XL883 Sportster introduced in 1959 two years after the original. “CH” supposedly standing for “Competition Hot.” These were stripped-down models oriented toward on- and off-road work with magneto ignition, high exhaust pipes, solo seat, smaller “peanut” tank, and lighter overall weight.
How big is a drag Daddy mini bike frame?
Drag Daddy Mini Bike | New 44 Drag Bike Double Loop Frame 1 inch Mild Steel Tubing, Bearing Steering Stem, 1 inch Front Forks, 7/8 inch Drag Handle Bar, Wider Rear Loop For Larger Rear Wheel and Tire, 44 inch Wheel Base, and more! For Track use only.
What kind of parts do you need for an Ironhead?
Things like engine gasket sets, carburetor kits, fork seals, levers, cables, brake pads and more to help you resurrect and maintain your Ironhead. We also believe that any machine can be turned into a Café Racer, Street Tracker, Bobber or Chopper and we offer a wide selection of parts to retrofit almost any beast in those traditional styles.