How do you attach throttle cable to carburetor?
Attach the new throttle cable to the throttle linkage on the carburetor. Install the carburetor mounting screws onto the choke plate and lever. Secure the carburetor (and choke plate) to the engine with the (2) screws. Note that the choke lever and the wavy washer must be properly aligned before tightening the upper screw. 8.
How do you replace the throttle cable on a Ryobi?
Reattach the carburetor (and throttle cable). Attach the new throttle cable to the throttle linkage on the carburetor. Install the carburetor mounting screws onto the choke plate and lever. Secure the carburetor (and choke plate) to the engine with the (2) screws.
Why do I need to replace throttle cable?
The throttle cable is the linkage between the throttle trigger and the carburetor. A common problem with the throttle cable is that the small connectors (on both ends) can become fatigued and break. It’s also somewhat common for the cable itself to become kinked or otherwise damaged during use. Replacing the throttle cable is easy to do.
How do you install a carburetor on a Ryobi?
Install the carburetor mounting screws onto the choke plate and lever. Secure the carburetor (and choke plate) to the engine with the (2) screws. Note that the choke lever and the wavy washer must be properly aligned before tightening the upper screw.
How do you remove throttle cable from carburetor?
On single cable carbureted applications featuring round or oval slide carburetors, unscrew the top cap of the carburetor where the throttle cable enters the slide. Compress the return spring and carefully remove any necessary hardware securing the cable end to the slide.
What’s the best way to clean a throttle body?
Let the cleaner soak in for a minute or two. Spray throttle body cleaner on a clean shop rag and clean the inside of the throttle body. Start by cleaning the inner housing and wipe the rag along the entire surface. Open the throttle blades with the throttle control.
How do you adjust the throttle cable on a transmoto?
Remove any dust covers from your throttle cable housing and determine which cable is the accelerator and which one is the decelerator. To adjust the cables, the locknuts are loosened and the cable adjusters are turned in to slacken or out to tension them. This can be accomplished by hand or with an appropriately sized wrench.
Do you need to replace throttle cable on Harley?
You may need to fix or replace the throttle cable and don’t want to pay expensive mechanics fees. We show you how do this project right in your shop or garage and right on the kickstand. No specialty tools are needed. If you want to put taller aftermarket handlebars on your Harley you will need to remove and install longer throttle cables.