Where do you drain oil on a Harley Davidson?
Drain the transmission oil. The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
How do you do an oil change on a Harley?
Shut the motor off, install a new oil filter that you pre-filled with new oil, run the motor and top off the oil tank as required. We used to call it the “5-quart oil change”. Remove the oil filter. Drain the old oil in the conventional manner. Re-fill the oil tank. WITHOUT installing a new oil filter.
Where is the transmission drain plug on a Harley Davidson?
The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
How much oil do you put in a Harley Davidson engine?
Fill the engine oil tank. The engine oil capacity is 3 quarts (2,800 ml; 100 imp fl oz). Most likely there is still oil left over in the sump, so fill it with 2 quarts (1,900 ml; 67 imp fl oz) and check the dip stick. Add oil until the oil level is between the low and high indicators on the dip stick.
Can you do an oil change on a Harley?
Harley-Davidson oil change is one of the most common DIY projects. Follow along as Bob teaches you how to drain the fluids on your Harley Softail, including the primary, engine oil and the transmission drain plugs.
Drain the transmission oil. The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
How do you fix a Harley Davidson oil filter?
Spin the new filter onto its mount and hand tighten. Next, you will prep your drain plug. Remove the old ring and clean the plug thoroughly. Then, apply Teflon paste to the threads. Start the drain plug into the oil pan by hand. Snug it; and final tighten to 14 – 21 foot lbs.
How to do an oil change on a Harley Davidson Twin Cam?
Screw the filter on until the gasket makes contact with the oil filter housing, then turn it another 3/4 or a turn. This must always be done by hand. Never use a wrench to tighten an oil filter. Drain the primary chain case. This is the beginning of the final leg of your oil change. Find the drain plug in the bottom side of the chain case.
How to change transmission fluid on Harley Davidson Softail?
If playback doesn’t begin shortly, try restarting your device. This channel is for mostly unscripted “How To” videos and commentary on a wide range of topics, but primarily car, truck, motorcycle & electronics repair and maintenance.
Screw the filter on until the gasket makes contact with the oil filter housing, then turn it another 3/4 or a turn. This must always be done by hand. Never use a wrench to tighten an oil filter. Drain the primary chain case. This is the beginning of the final leg of your oil change. Find the drain plug in the bottom side of the chain case.
Why is there no oil in my Harley Davidson tank?
Drained some out and did not have a problem for the rest of the season. I recently removed the plugs, turned over the engine to try to push the oil back into the tank, no luck. The oil light is off and no oil leaked out while the bike was sitting.