How do I reset my Suzuki outboard computer?
How to Reset the Suzuki® Outboard Oil Alarm
- Turn on the ignition switch.
- Remove the emergency stop switch lanyard.
- Pull out the stop switch button 3 times in 10 seconds until you hear a beep.
- Turn off the ignition switch and reinstall the stop switch lanyard.
How do you start a Suzuki engine?
With your foot off the accelerator pedal, crank the engine by turning the ignition key to “START”. Release the key when the engine starts. CAUTION: Stop turning the starter immediately after the engine has started or the starter system can be damaged.
How do I reset my mercury ecm?
Turn on the key switch. Pull the safety switch to off, then push to on, then pull to off, then push to on, then pull to off, then push to on, then pull to off, then push to on, then pull to off. That should be five times off and on and off within 20 seconds from when you turn the key switch to on.
Why won t my Suzuki vitara start?
While there are a variety of reasons your Suzuki Vitara won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
What to do if your Suzuki outboard motor is not starting?
Common problems in Suzuki outboard motors can be easily diagnosed from home. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine. The primer bulb and entire fuel line may have to be replaced.
How many horsepower does a Suzuki outboard motor have?
They can range from 2.5 horsepower to 300 horsepower. Outboard motors are attached externally to the stern. Common problems in Suzuki outboard motors can be easily diagnosed from home. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine.
Why is the neutral switch on my Suzuki outboard not working?
1) Spliced connections that have gone bad. Connectors not waterproofed that allow for unseen corrosion. 3) Ground wire fails. 6) If you have power to the ECM and starter fails to kick in, one of several more reasons can relate to the neutral switch.
What does the ignition switch do on a Suzuki outboard?
The ignition switch does several things- in the ‘ON’ position it is the primary power source to the ECM. At this point, for 4 cycle engines, a relay turns on the high pressure fuel pump. You should hear this pump.
How to troubleshoot a Suzuki outboard motor problem?
1 Motor Won’t Start. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine. 2 Power Loss. Check the spark plugs and filter if there is a sudden and noticeable drop in power while the engine is at full throttle. 3 Vibrations. Inspect the propeller for damage.
They can range from 2.5 horsepower to 300 horsepower. Outboard motors are attached externally to the stern. Common problems in Suzuki outboard motors can be easily diagnosed from home. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine.
Why does my Mercury outboard 115 not start?
The most common sources of problems are the internal water passages, the fuel line, propeller and spark plugs. If the Mercury Outboard 115 will not start, this can indicate a variety of things. A simple issue may be that the spark plugs need replacing. Another issue may be that fuel line is clogged and fuel isn’t reaching the engine.
Are there any problems with the Suzuki df140?
I had the same issue with 2006 DF140. Engine ran a little rough at idle, hardly noticeable, and would stall when going from full throttle to idle and vice versa. I was getting the same 3-2 map sensor code.