How do you remove a battery from a Harley Davidson Road King?
Step 1 Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
How do you remove a seat from a motorcycle?
Remove the screws or bolts toward the center edge of the seat. Remove the screws or bolts from the front of the seat. Push the seat toward the gas tank to release it from the plastic pin holding it in place.
How do you remove the passenger seat from a road King?
Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat.
Where is the battery located on a Yamaha motorcycle?
On most Yamaha motorcycles, the air filter and the battery are located under the seat. The seat is usually secured to the bike’s frame by three to six screws or bolts. The size and type of the bolts or screws will differ between bike models, so you’ll need a tool set.
Step 1 Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
Do you have to remove the seat on a Harley?
You should begin every service, or repair with Harley Battery removal and Harley seat removal. The most important part would be disconnecting the battery negative cable.
When to remove the battery from a Harley Sportster?
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat.