Is there a turn signal on a Harley Davidson?
Solves all led turn signal problems: No flashing, fast flashing, burned out bulb indicator. Plug and play, no cutting and splicing required. Some Harley’s are wired differently. Minor wiring adjustment is required. Warning: Extremely Hot when in use. Do not mount on plastic. Make sure it’s not touching any wires.
Where is the turn signal module on a Street Glide?
Jonathan, sounds like you have a bad turn signal module. You will find this module between the fuel tanks, beneath your dash area. Thanks, and good luck Similar Question Been enjoying the videos and tips I have a 2008 Street glide with 90K miles on it. I always took it to the dealer until I found your website and got the premium membership.
What are the issues with LED turn signals?
LED caused 3 issues for me, fast flash, turn indicators glow when not on & ignition light stays lit. Fixed fast flash & ignition light but turn indicators still glow and now all four turn signals flash when brakes applied. Flashing lights while braking is not a terrible thing but it is not really what I wanted.
What to do when your turn signal is not working?
They are sealed. There are no bulbs to change for the indicators on your year/model. Usually, when one fails, however, it is due to a bad connection or switch. Suggest trying to externally ground the wire @ your neutral switch. If your neutral indicator lights up, then the switch is bad.
How do you reset the turn signal on a Dyna Glide?
Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.
How do you reset the turn signal on a Harley Davidson?
Press left turn signal switch twice, pause, and lights will flash. Press right turn signal switch once, pause, and lights will flash. Press right turn signal switch once, pause, and lights will flash twice. Press right turn signal switch once, pause, and lights will flash three times.
What to do when your turn signal doesn’t work?
Turn the ignition to run/stop in run position with ignition off. Hold ODO reset button in and hold. Turn ignition switch to IGN. Release ODO reset button. Background should light up, speedometer needle should sweep its full range and indicator lamps (battery, security, low fuel, check engine and cruise) should all light up.
Are there brake lights, turn signals or cruise?
Discussion in ‘ Touring Models ‘ started by TXViper, May 19, 2009 . I have a 2009 Street Glide and just had the horn, cruise, turn signals, and brake light all quite working. I don’t have any blown fuses, and the turn signals still flash when I turn the ignition off indicating that the security system is activated.