Why is my turn signal not working on my Road King?
Im going through the same thing right now with my 15 road king, I ordered a new harness got it plugged it in now neutral light comes on with switch turned off or on, everyone said change wiring harness mine signals work but lt turn and high beam don’t, Help Schmiddty? Click to expand… I haven’t run into this problem yet.
Why is the blinker on my Harley Davidson not working?
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
Are there any problems with a Harley Davidson Road King?
Problem today: there are still a lot of bikes of those years (built date on bike frame) out there that have NOT had a problem YET or NOT been repaired by the owner before coming apart…. BE CAREFUL MY 2000 fxds was a problem child and I DID ALL the repairs on my dime…..
Why are my turn signals not flashing on my Harley Davidson?
If you are stuck with having to manually cancel the turn signals, the problem could be found in connectivity to the speedometer or the TSSM. Check the switches. Check for loose or disconnected wires to the speedometer. Check the tip switch that cancels if the bike falls over.
Why are my blinkers not working on my bike?
Also consider what kind of work was recently done on the bike that might have affected the blinker system. For example, a connector may not have been pressed in all the way and disconnected itself from the vibration. If the fuses, connections and wiring looks okay, check the bulbs. Flashers work but turn signals don’t.
If you are stuck with having to manually cancel the turn signals, the problem could be found in connectivity to the speedometer or the TSSM. Check the switches. Check for loose or disconnected wires to the speedometer. Check the tip switch that cancels if the bike falls over.
Where is the bank angle sensor on a Harley Davidson?
On some bikes it’s called a Bank Angle Sensor (BAS) and is located in the Turn Signal Security Module (TSM or TSSM). Check and clean your speed sensor. It may seem irrelevant but the TSSM serves many functions. Timing for turn signals is picked up by the speed sensor to control the time out distance/time.
What to do if your blinker blinks too fast?
If you have blinkers that blink too fast, go to Step 4. When you are getting deeper into your troubleshooting project, give yourself plenty of time. Be careful not to disconnect other wiring while you are going through the harness.
Im going through the same thing right now with my 15 road king, I ordered a new harness got it plugged it in now neutral light comes on with switch turned off or on, everyone said change wiring harness mine signals work but lt turn and high beam don’t, Help Schmiddty? Click to expand… I haven’t run into this problem yet.
Is there a problem with the throttle on a 2009 Harley?
& filed under Harley Tips. Q: 2009 Harley Ultra Classic w/25K no past problems in the past, but on 07-12-14. I had a problem with what I found out and is called “Limp Mode”! no throttle response at all other than running at idle. Error codes I found on the bike were; P1511 & P2135. all having to do with the Harley throttle control.
What causes a bad shift fork on a Harley Davidson?
Causes can include a bent shift fork, bad bearing on the transmission input or output shaft, or other worn parts. A bad/bent shift fork no longer move the gears the correct distance, which prevents complete engagement of the next gear set.