What do I need to know when my ATV wont start?
Activate the starter. You should see repetitive bright blue spark arching from the spark plug to the cylinder head as the motor turns. You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post.
What should the voltage be on an ATV battery to start it?
The battery should read 12,6 – 12,8V. Use a multimeter or a voltmeter to check the voltage. If the voltage drops too low, the battery won’t have enough charge to start the bike. Charge the battery or replace it if it’s dead.
What should I do if my bike wont start?
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.
Where is the solenoid on an ATV starter?
The solenoid is usually located near or on the starter. Put your multimeter to DC Voltage. The red lead goes to the battery (red) side of the solenoid. The black lead goes to ground. You should get a voltage reading of 12V or more.
What to do when your ATV won’t start?
If your ATV doesn’t crank at all when you’re trying to start it, there are a few basic things to look into. 1. Make sure the kill switch/run switch is in the “ON” or “RUN” position. You’d be surprised how often the solution to an ATV that won’t start is forgetting to turn on the kill switch.
The battery should read 12,6 – 12,8V. Use a multimeter or a voltmeter to check the voltage. If the voltage drops too low, the battery won’t have enough charge to start the bike. Charge the battery or replace it if it’s dead.
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.