How do you change the brake light switch on an EL Falcon?
Remove the clevis pin from the pin securing the switch to the pedal. Slide the pin out, noting the position of the nylon bushes. Remove the old switch. Slip the new switch into position, locate the bushes and slide the pin back in. That’s the theory. In practice it’s a bit fiddly and frustrating.
Why are my brake lights not working on my Ford Falcon?
If you are getting a few honks and hostile people passing your Ford Falcon on the road, maybe it’s because your brake lights are not working. It is common for a brake light bulb to blow now and again, but for all your vehicle’s brake bulbs to blow at once is definitely not typical.
How to change the Ford FG brake switch?
How to change the Ford FG Brake Switch. If your FG is throwing DSC, ABS or brake faults there’s a good chance it’s just a faulty brake switch. Get yourself a new one with some spare change and swap them out. That’ll probably fix it good as new! Shirts available soon! Loading…
How do you replace a brake light switch?
lay under the dash, with your head in a position to see the switch. disconnect the harness connector. use a spanner to remove the nut, may need to use your other hand to stop the switch rotating. remove the switch and install new one in reverse order, but:
Remove the clevis pin from the pin securing the switch to the pedal. Slide the pin out, noting the position of the nylon bushes. Remove the old switch. Slip the new switch into position, locate the bushes and slide the pin back in. That’s the theory. In practice it’s a bit fiddly and frustrating.
Can you replace the tail light on a BA Falcon?
Short video on how to replace the Brake, Indicator or Reversing tail lights on a BA Ford Falcon – included is the replacement of the tail light wiring loom which is what holds the globes inside the outer casing. I didn’t have any luck in finding non genuine parts regarding the wiring loom so I had to use Ford parts.
lay under the dash, with your head in a position to see the switch. disconnect the harness connector. use a spanner to remove the nut, may need to use your other hand to stop the switch rotating. remove the switch and install new one in reverse order, but:
Is there a nut to undo on an EL Falcon?
There is no nut to undo on a EL Falcon. There is a spring loaded clip that retains the switch onto the pedal shaft. There is also no adjustment on a Falcon, but there are 2 nylon bushes that have to go in a specific order. Pay special attention to it when removing so you can re fit in correct order