Do Kawasaki Mules have Governor?

Do Kawasaki Mules have Governor?

the “governor” on the Mule 610 is really a mechanical speed limiter…it is connected to the driveline and will keep the vehicle from exceeding it’s “governed” speed…on my mule, going down a steep grade i noticed it would do it’s best to hold me back…

Is there a speed limit on a Kawasaki Teryx?

As a matter of fact, the Teryx is governed at around 50 MPH from the factory. So if you want to go any faster than that, the first thing you’ll need to do is eliminate said speed governor. The easiest way to remove speed limits on the Kawasaki Teryx is to have an ECU reflash done.

Is there a problem with my Kawasaki MULE 4010?

I took my 2016 Mule 4010 Trans 4×4 in for 500 hour service last week. to open a gate or something. When running at half to full throttle, it was fine, but would surge and run unevenly when at low RPMs. might arise again in the future. Mule owners had returned almost immediately with the same problem. She indicated

Can a throttle stop screw be adjusted on a Kawasaki?

I can, however, also say that adjusting the throttle stop screw usually ruins the throttle body. Kawasaki does not give specific sensor values and throttle opening angles that are to be followed when/if the screw is adjusted.

How often should I Run my Kawasaki ATV in low gear?

Educate your customer that the engine is an industrial engine and that if they use it at idle/low speed all the time, it’s advisable to throw it in low gear (on the 4×4’s) and run the engine against the governor for a while about once a week. This will prolong the same thing happening.

How to increase the top speed of your Kawasaki UTV?

Like with the Teryx and Mule, a tune will increase the top speed of your Kawasaki KRX. And as far as KRX tunes go, the Alba tune is among the best. That being said, however, although you’ll see a greater throttle response and quicker accelerations with a KRX tune, some additional clutch work will be required to hit faster top speeds.

As a matter of fact, the Teryx is governed at around 50 MPH from the factory. So if you want to go any faster than that, the first thing you’ll need to do is eliminate said speed governor. The easiest way to remove speed limits on the Kawasaki Teryx is to have an ECU reflash done.

How did I eliminate the speed governor of a mule Kawasaki?

How did I eliminate the speed governor of a Mule Kawasaki… I have a 2010 Kawasaki FR651V 22 HP v twin. It just started Hi, I have a 2010 Kawasaki FR651V 22 HP v twin. It just started surging as low RPM. I have clean 100% gas, fuel filter was changed about 30 days … read more Kawasaki mule turns over but won’t start. Checked all that.

How to increase the top speed of a Kawasaki MULE?

An easy way to increase the top speed of your Kawasaki Mule is to make sure that the tires are fully inflated — the flatter your tires are, the slower you’ll go. Disabling the governor is another action you can take to reach faster speeds.

Posted In Q&A