Where to drill pilot holes on Harley Davidson?
Position the template (19) from the kit across the rear of the Tour-Pak, aligning the template around the hinge on the left side and the latch on the right. Tape the template securely to the Tour-Pak. Drill 1.5 mm (1/16 in) diameter pilot holes through the template and Tour-Pak at fourteen marked locations.
How does the wrap around light on a Harley Davidson work?
Apply a small amount of silicone sealant around the base of the seven threaded studs (A) on the back of the LED Wrap-Around Light assembly (1) to prevent water leakage into the Tour-Pak. The LED Wrap-Around Light assembly mounts to the Tour-Pak with the antenna holes (B, C) facing UP.
How do you remove the mast from a Harley Davidson?
Open the Tour-Pak lid and, if necessary, remove all items from inside the Tour-Pak. Models with molded liner: Open the pouch and remove the acorn nuts with flat washers. Remove the pouch and liner. Remove the mast from the antenna, and set aside for later installation.
How do you fasten a light on a Harley Davidson?
Fasten the light assembly with the seven flange nuts (18), but do not fully tighten at this time. From the inside of the Tour-Pak, use the four TORX ® pan head screws (7) and washers (8) to fasten the light assembly at the sides. Tighten securely. Alternately tighten the flange nuts securely.
Where are the anchor plates on a Harley Davidson?
The anchor plates will stay secure under the floor once you have secured them with 2 carriage bolts at the time of installation. All that is visible on the top side of your trailer floor are the head of the carriage bolts and a 5/8” hole in your floor. Yes, it works on all Harley Davidson motorcycles.
Can a Harley Davidson be loaded with a biker bar?
Take your bike, ditch the straps! The Biker Bar is a totally unique concept and a complete departure from the cumbersome straps, chocks and bolt-on systems that can be ineffective, unsightly and cause damage to paint, chrome and leather finishes. Load and unload your Harley Davidson in less than a minute by yourself with the Biker Bar.
Where do I Find my instruction sheet or part number?
Where do I find my Instruction Sheet or Part Number? You can find your Instruction Sheet number at the top of the page, located in either one of two places. You can find your product part or kit number located on the printed sheet which came with the parts packaging or locate it on the packaging itself.