How to install a clutch cover on a car?
Place the clutch cover pressure plate assembly over the clutch disc. Ensure that the disc is precisely centered to the pressure plate for proper alignment. Apply pressure. Tighten/torque bolts in a diagonal pattern. DO NOT use air tools to install a clutch cover assembly.
What should you know before installing a clutch?
Malfunctions, including wear and tear and breakage, must be properly addressed (corrected, replaced) before installing a new clutch. Use only the specified clutch. Malfunctions may result from using clutches that are not correct for the application.
How to replace a starter clutch on a Harley Davidson?
Just basic tools are needed and no specialty tools are required. Contact your Harley Davidson dealership to order the correct starter clutch for your year and model. The starter clutch can fail after years of use and these things happen.
What should I do if my clutch cable is leaking?
Place one end of the cable into the bag and wrap a rubber band around it so the fluid won’t leak out. Next, turn it upside down and allow the fluid to drain down the clutch cable until it drips out the other end. Quick, simple and clean as long as you get that rubberband tight enough.
How many Amazon pull clutch levers are there?
Only 16 left in stock – order soon. . Only 1 left in stock – order soon. . . Only 3 left in stock – order soon. . . Only 10 left in stock – order soon. . . Only 13 left in stock – order soon. . Only 12 left in stock – order soon. . Only 11 left in stock – order soon.
Do you remove the disc from the clutch assembly?
Do not remove from the system from the clutch assembly. Dual Friction Clutch assembly is designed to provide a positive engagement with daily drivability. Install the Dual Friction disc with side indicating “Flywheel Side” against the flywheel (typically the segmented or puck style facing as shown).
When does the face align with the clutch assembly?
The face will align with the clutch assembly once the pedal has been cycled several times. Centrifugal Weight System is designed to provide the clutch with increased holding capacity as RPM increase. Do not remove from the system from the clutch assembly.
What should I know about replacing clutch bolts?
Clutch hardware must endure high loads! Be sure replacement bolts are of high quality and match OEM bolt configuration (i.e. if stock bolts are shouldered, replacement bolts should be shouldered as well.) What are the clutch bolt torque specifications?