How do you replace the Bendix on a starter motor?
Replacing the Bendix on a pre-engaged starter motor. Reassemble by sliding on the pinion-and-clutch assembly, the thrust collar and the jump ring. Use a small puller to draw the thrust collar back up over the jump ring. If it is one of the alternative types of collar, use a drift to tap it back on.
What’s the best way to replace a Bendix gear?
Remove the starter (See Checking and replacing the starter motor ) and clean the gear thoroughly with petrol and a paintbrush. Let it dry completely: petrol fumes can explode. Test the gear by sliding the pinion along the shaft. It should slide easily and return under the spring pressure . Do not oil the gear: that would attract more dirt.
What causes a starter to spin without engaging the flywheel?
However, the term is sometimes used for the pre-engaged starter mechanism. Drive-mechanism faults can occur in two ways. The starter can spin without engaging with the flywheel , or jam in engagement. In an inertia starter, dirt in the spiral Bendix thread is the usual reason for it not engaging.
Why is my inertia starter not working properly?
In an inertia starter, dirt in the spiral Bendix thread is the usual reason for it not engaging. Remove the starter (See Checking and replacing the starter motor ) and clean the gear thoroughly with petrol and a paintbrush.
Can a DB Bendix drive be used as a starter?
A DB Electrical Bendix Drive restores precision mechanical engagement of the pinion gear to the flywheel. Replacing a worn Bendix drive can renew the performance of a starter.
How do you replace the Bendix on a pre engaged starter?
Replacing the Bendix on a pre-engaged starter motor. Look at each side of the collar to tell which type it is: push or pull it away from the side on which the jump ring is just visible. The entire pinion-and- clutch assembly can now be lifted off. There may also be a clutch stop bracket fitted over the shaft.
How to spin a starter on a Bendix Steiner tractor?
Improved ratchet style design. …the starter drive back off from the starter motor shaft. Slide the spun starter drive onto a large heavy screwdriver handle. Make sure to wear your safety glasses before the next step. Now you need to turn on your wire wheel. Place the starter gear against the wire wheel in order to spin the starter …
Remove the starter (See Checking and replacing the starter motor ) and clean the gear thoroughly with petrol and a paintbrush. Let it dry completely: petrol fumes can explode. Test the gear by sliding the pinion along the shaft. It should slide easily and return under the spring pressure . Do not oil the gear: that would attract more dirt.