When was the last Shovelhead made?
The Shovelhead engine is a motorcycle engine that was produced by Harley-Davidson from 1966 to 1984, built as a successor to the previous Panhead engine.
When did the Sportster clutch issues found me?
Discussion in ‘ Sportster Models ‘ started by jterby, Jul 1, 2010 . Hi everyone. I just thought I’d post a quick…look what happened to my bike message. I had some clutch adjustment issues recently, and have now found the problem. I did the typical stuff that is suggested on this site. I bought the service manual.
How much does it cost to replace stock clutch on Sportster?
I just thought I should give the heads up to everyone to watch out for slipping or dragging on the stock clutches. If it does, get in there and change out those weak parts to steel or whatever and move on. It’ll be cheap at that point…like $40.
What’s the problem with a Muller power clutch?
Skip the Muller power clutch, the problem with them is in the mechanism where you have two eccentric wheels with a spring and until you get the spring over the center point, the pull is not reduced but actually a bit stiffer. Check this unit out. Glider I appreciate the quick response.
Is there a problem with the clutch on a Harley Davidson?
BT you turn adjuster IN until you feel drag, then back off a 1/2 to full turn. XL models, you turn the screw OUT till it seats, then in a 1/4 turn. Chain too tight. Usually just makes neutral hard to find. No…..if clutch was south, it would slip.
Discussion in ‘ Sportster Models ‘ started by jterby, Jul 1, 2010 . Hi everyone. I just thought I’d post a quick…look what happened to my bike message. I had some clutch adjustment issues recently, and have now found the problem. I did the typical stuff that is suggested on this site. I bought the service manual.
BT you turn adjuster IN until you feel drag, then back off a 1/2 to full turn. XL models, you turn the screw OUT till it seats, then in a 1/4 turn. Chain too tight. Usually just makes neutral hard to find. No…..if clutch was south, it would slip.
I just thought I should give the heads up to everyone to watch out for slipping or dragging on the stock clutches. If it does, get in there and change out those weak parts to steel or whatever and move on. It’ll be cheap at that point…like $40.
When did the clutch issues on my Nightster start?
My bike is a 2008 Nightster and my issues started between 15,??? -16,200 miles on the Od. I took it to a smaller custom barely shop, to try and save some $$$. They said they would try the adjustments first and if nothing improved would look inside.