How do you adjust the headlights on a hyundai Accent?
Draw a vertical line (through the center of each headlight beam pattern) and a horizontal line (through the center of each headlight beam pattern) on the aiming screen. And then, draw a parallel line at 0.8 in. (21 mm) under the horizontal line.
How do you adjust the headlights on a hyundai Sonata?
How to adjust the headlights of a Hyundai Sonata?
- Place your car on a surface in front of a white wall for example, about 4 or 5 meters from the wall.
- Verify your tire pressure cautiously.
- Verify that the height adjustment knob for the lights is set to 0.
- Try doing that with half a full tank.
How do you adjust the headlights on a Hyundai?
Turn your low beam headlights on and check the aim against the marks on the wall. Use a Philips or Torx screwdriver to twist the screws. Adjust each headlight until the beams hit the marks on the wall. Ideally, you want the highest intensity zone of the lights to be slightly lower and to the right of the marks.
How do you adjust the headlights on a Honda Accord?
Turn on your headlights and prop open the hood. Look behind each headlight assembly for the two adjustment screws. Twist these with your fingers or a screwdriver to adjust the vertical and lateral aim of the headlights.
How do you adjust the headlight on a garage door?
Remove the two rubber stoppers, one covering each hole, by pulling them out with your fingers. This will expose the adjustment screws. Turn both screws until the headlight beam shines straight forward and toward the bottom of the flat surface where the garage door or wall meets the ground.
What’s the best way to adjust headlight aiming?
Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver – VERTICAL AIMING. WARNING: Never attempt to adjust the horizontal alignment of your headlights. Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights.
Turn your low beam headlights on and check the aim against the marks on the wall. Use a Philips or Torx screwdriver to twist the screws. Adjust each headlight until the beams hit the marks on the wall. Ideally, you want the highest intensity zone of the lights to be slightly lower and to the right of the marks.
Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver – VERTICAL AIMING. WARNING: Never attempt to adjust the horizontal alignment of your headlights. Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights.
When to adjust horizontal aiming on a Hyundai?
Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration.
Turn on your headlights and prop open the hood. Look behind each headlight assembly for the two adjustment screws. Twist these with your fingers or a screwdriver to adjust the vertical and lateral aim of the headlights.