How long does a UTV belt last?
Generally, branded ATV belts last for a long time, if you follow the riding guidelines mentioned in the owner manual properly. If maintained properly, belts can last between 3000-5000 miles.
How do you change the drive belt on a Polaris Ranger?
Step 1. Remove the left rear wheel. PRO TIP: You can change a Polaris Ranger 900XP drive belt with the wheel still in place, but removing the wheel makes the job much easier. Step 2. Tilt the rear cargo bed back, and remove the three 10mm bolts holding the airbox in place.
How to replace the drive belt on a Polaris Sportsman 500?
Place the drive belt cover into position and tighten in place using the screwdriver. Start the ATV and slowly increase the throttle until the drive belt engages the drive train. “Clymer, Polaris Service, Repair, Maintenance 2001-2003”; Primedia Publishing; 2003
How do you change clutch on Polaris Ranger?
Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4. Pull the bottom of the cover outward and over the suspension to remove it.
What happens if the belt fails on a Polaris Ranger 500?
If a belt fails on your Polaris RANGER 500, always clean any debris from the clutch air duct and from the clutch and engine compartments when replacing the belt. Failure to remove all debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death.
How do you change drive belt on Polaris Ranger?
The replacement belt is part number 3211169. Follow these steps to replace your drive belt: 1. Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4.
Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4. Pull the bottom of the cover outward and over the suspension to remove it.
If a belt fails on your Polaris RANGER 500, always clean any debris from the clutch air duct and from the clutch and engine compartments when replacing the belt. Failure to remove all debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death.
How can I tell if my Polaris Ranger needs service?
If any seals appear to be damaged, your RANGER requires prompt service. Your Polaris Dealer can assist. To find a dealer near you, use the Dealer Locator. Tip: Belt slip is responsible for creating excessive heat that destroys belts, wears clutch components and causes outer clutch covers to fail.