How to adjust valves on Suzuki King Quad 300?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: hAnKw5A068rBCaUY)
What should clearance be between intake valve and rocker arm screw?
Measure the clearance between the front cylinder intake valve — the valve closest to the carburetor between the cylinders — and the rocker arm adjustment screw, using a thickness gauge. There should be between 0.003 to 0.005 inch of clearance between the valve and screw.
How often should you change the valve on a motorcycle?
Even so, the engine’s valve train requires an inspection and adjustment every 7,500 miles. Don’t let the apparent complexity of the job scare you off; equipped with a small assortment of tools, you should be able to not only check, but also adjust, the valves. Park the motorcycle on its side stand and let it cool completely.
What happens if you adjust the clutch on a Suzuki Intruder?
An improperly adjusted clutch will cause the clutch to slip and make it hard to shift gears. Pull back the rubber cover of the clutch lever to reveal the lock nut and adjusting screw. Loosen the lock nut with a wrench.
What are the intake and exhaust valves on a Suzuki?
At 137,000miles you probably need more than that to continue your trouble-free drives. You can’t post conmments that contain an email address. valve clearance, with engine hot, intake valves are .005-.006 in, exhaust valves are .011 in, if engine is cold then its intake .009-.011 in and exhaust is .007. hope this helps good luck.
How to adjust the valve lash on a Suzuki Sidekick?
SOURCE: Need help adjusting the valve lash on a 93 suzuki sidekick 1.6 liter 16 valve engine. What is the procedure . i need to adjust is the exhaust lash i didnt mess with the intake lash with camshaft out. its a 60,000 mile service point with new cam belt.
Even so, the engine’s valve train requires an inspection and adjustment every 7,500 miles. Don’t let the apparent complexity of the job scare you off; equipped with a small assortment of tools, you should be able to not only check, but also adjust, the valves. Park the motorcycle on its side stand and let it cool completely.