Why are my bike headlights dim?
Most DIYers think they’ve got a bad headlight switch or a bad connection in the power feed. But most dim headlights are caused by a corroded ground wire. Just trace the wiring harness from the back of each headlight assembly and see where it connects to the vehicle body.
Why are my bike lights not turning on?
Polarity (orientation of the wires when plugged into the lights) is critical with battery powered DC lights. Reversing polarity can destroy your lights or damage your battery. Always ensure correct polarity when connecting wires. Do not short connectors.
What should I do if my motorcycle battery wont start?
If you don’t see these symptoms or are otherwise unsure what to look for, the first step is ensuring that the battery is operational and providing the maximum voltage. To confirm your battery is still good, you should visually inspect it, check the voltage, and load test the battery. A visual battery inspection should involve:
What to do when your electric bike won’t turn on?
Check the full wiring run to make sure there is nothing disconnected or damaged. Wiring can sometimes run through the frame, fenders, and racks; don’t pull or remove it, just check what is easily accessible and visible. Use a multimeter to check the output voltage of the dynamo while the wheel is spinning. It should read approximately 6V AC.
What does it mean when your motorcycle won’t start?
Not every rider uses their kill switch with regularity, but if you have used it recently, it’s possible the engine cutoff switch is still activated. Either that or someone else flicked it, or you did it by accident—either way, it’s worth a quick glimpse, as the switch remaining in the on position will prevent the motorcycle from starting.
What happens when the lights go on but no cranking?
The lights go on, but the electric start does nothing – no cranking. Please read the history below to understand more because I’ve had had several prior electrical issues. 1. A 1.5V battery. I left my bike for about 5 days a week ago. I turned the key ignition on and found the battery to be near dead.
Why do the lights on my bike not work?
However, the electric start still doesn’t work. I also noticed that several times (but not all the time), when I was pressing buttons like the electric start or the high beam, my bike would die again and I would have to wiggle the ignition unit again to get lights. I also tried run-starting it, but no luck.
What does it mean when your bike won’t start?
It would not start up there after. The battery is fine, tested and it is at peak power. Lights are working, dash lights working, but the engine will not turn over or even make a sound when I try to start it up now.
Why are the lights on but no electric start?
The light that came on was the engine oil light, but it was incredibly faint. Turn lights = no, electric start=no. Checked the battery and it was at 1.5volts. Figured it was a dead battery, but I tried to salvage by hooking up a 1.5a charger.