What kind of engine does the Polaris Magnum 325 have?
The Magnum 325 uses a four-stroke, air-cooled (with fan-assisted stage 3 oil cooler) single-cylinder engine. It has a bore-stroke ratio of 78 mm x 68 mm (3.07 x 2.68 inches).
How does the carburetor work on a Polaris ATV?
The carburetor on your Polaris ATV is used to bring fuel into the engine. If you are getting stalls or your engine will not turn over, you need to adjust the carburetor. Jet pins and an air adjustment valve are attached to the carburetor. This valve will allow you to reduce or increase the air flow to your engine.
Where are the jet pins on a Polaris carburetor?
If you do not, you might burn your hands while adjusting the carburetor. Locate the gold pins on the side of the engine. The fuel jets and the air valve are on the bottom of the engine. Open the owner’s manual and locate the adjustment chart. Tighten the jet pins with a screwdriver until they will not go any tighter.
Where is the drain plug on a Polaris Magnum 325?
1. Place your Polaris Magnum 325 on a level surface. Run the engine for 2-3 minutes until warm to make the oil flow smoothly. Stop the engine afterward. 2. Clean the drain plug area at the bottom of the oil tank, located on the vehicle’s left side. 3.
Can a CARB be rebuilt by a Polaris dealer?
I just had the carb rebuilt by a Polaris dealer. It runs great. Idles perfect, accelerates great, perfect. That is until it dies. It acts like it runs out of gas OR the spark fails. I put a new fuel filter, fuel pump, and nice fresh gas on it. I seen on the polaris site that the spark plug cap can be bought apart from the coil.
What kind of CARB does a Polaris Magnum have?
I have a 2002 Magnum 500 RMK. I just had the carb rebuilt by a Polaris dealer. It runs great. Idles perfect, accelerates great, perfect. That is until it dies.
If you do not, you might burn your hands while adjusting the carburetor. Locate the gold pins on the side of the engine. The fuel jets and the air valve are on the bottom of the engine. Open the owner’s manual and locate the adjustment chart. Tighten the jet pins with a screwdriver until they will not go any tighter.
How do you adjust the carburetor on a Polaris ATV?
Turn off the engine and remove the ignition key. Wait for the ATV to cool. If you do not, you might burn your hands while adjusting the carburetor. Locate the gold pins on the side of the engine. The fuel jets and the air valve are on the bottom of the engine. Open the owner’s manual and locate the adjustment chart.