How do you remove a Harley Davidson pushrods?
Part 1 of 2: Quick and Easy Harley Pushrod Removal
- Step 1: Remove the retaining clips.
- Step 3: Rotate the engine until the tappet sits as low as possible inside the tappet block.
- Step 4: Now we are going to loosen each pushrod.
- Step 5: This is a step, but not really.
How do you remove a cam cover on a Sportster?
Unscrew the nine Allen bolts that hold the cam cover to the engine block and the cam support plate using a socket wrench and a 1/4 inch Allen socket. Remove the bolts in a “crossing pattern” which means you should remove the bolts in pairs that are on opposite sides of the cover rather than in pairs that are right next to each other.
How do you remove a pushrod on a Harley Davidson?
Once the retaining clips are out, the pieces of the pushrod assembly can be moved around a lot up and down around the pushrod. I have a set of baby bungee cords that come in handy here. Take a baby bungee or coat hanger, pull up on the bottom pushrod cover, and expose the bottom of the pushrod.
How do you remove ignition cover on a Sportster?
Remove the five ignition cover screws with a socket wrench and a Torx or Allen socket. The socket you use will depend on the year and engine model of your Sportster. Ignition covers on current models are fastened with T20 Torx screws.
When to replace the cam cover on a Harley Davidson?
Remove and discard the cam cover gasket. Replace this gasket when you begin to reinstall or replace the cam cover. Refasten the cam cover to the engine using the cross-pattern sequence described in the Harley-Davidson shop manual for your Sportster to tighten the Allen bolts.
How to install an ironhead Sportster pushrod kit?
A. Pushrod kits for Ironhead Sportster engines. (Part #93-5030 and #93-5035.) 1. Remove pushrod cover clips and lift cover assemblies to view lifters. 2. Remove spark plugs and rotate engine until the rear exhaust lifter is at it’s highest point. 3. Loosen front exhaust adjuster and remove pushrod and tube assembly. 4.
Once the retaining clips are out, the pieces of the pushrod assembly can be moved around a lot up and down around the pushrod. I have a set of baby bungee cords that come in handy here. Take a baby bungee or coat hanger, pull up on the bottom pushrod cover, and expose the bottom of the pushrod.
How to install pushrods on a car engine?
Apply a light coat of engine oil to o-rings. e. Insert new pushrods through tube assemblies and install in appropriate positions. f. Extend lifters to remove lash in pushrods. Adjust lifters to be able to spin pushrods with fingertips with a slight drag, and tighten locknuts. g. Repeat above procedures for rear cylinder. h.