Can a motorcycle have a fused accessory circuit?
Although the task is fairly simple, you’ll need to perform a little detective work before you start. Touring bikes frequently have a fused accessory circuit, but most other motorcycles do not. To suss out a switched circuit, all you need is a sharp eye and a little intuition.
Can you plug a Y-adaptor into a guitar amp?
Do NOT use a Y-adaptor to combine the stereo line level output of a device into the guitar amp’s instrument input. If you want to plug a stereo line level device into the guitar amp’s ¼” inch socket normally used to plug a guitar in, you need to use a mixer, such as the Behringer Micromix MX400.
What kind of input do I need for a turntable?
And from there, we need to connect the output from the turntable with built-in preamp or the output from the standalone preamp to one of the available LINE-level inputs on the receiver. It can be AUX, DVD, CD, TAPE, TUNER or any other LINE-level input that is available on your receiver.
How to connect an amp to a receiver?
Open up unit, trace down the internal pre-amp/processor section and amp modules and find the line level signal circuits between them. Cut circuit and bypass to external jacks that you install wherever space allows on back. I usually add switches for each channel pair to select between ‘bypass’ and ‘internal circuit’ modes.
How are amplifier gains set on a motorcycle?
Setting amplifier gains (amplifier input sensitivity) should not be done in exactly the same manner as it is done in car audio. There are a few very distinct differences in the equipment as well as the environment that a motorcycle stereo system is expected to perform in that dictate a difference in procedure.
What kind of amplifier does a Harley Davidson use?
Harley radios have speaker amplifiers built into them so that they can drive speakers directly without the need for an external amplifier. This amplifier is in play even when a bike is equipped with a factory Harley external amplifier.
How do you hook up a 4 channel amplifier to a radio?
There are 3 basic ways to get a signal to your 4 channel amplifier: Connect speaker outputs to your amp’s speaker level inputs. Connect a line-level adapter to the radio then use RCA cables to the amp. Connect your radio to the amp using RCA cables directly.
Can a 4 channel amplifier be used in a 2 channel car?
What a 4 channel car amplifier is may seem obvious at first but there’s a bit more to know Additionally, there are some interesting (and good) ways they differ from 2-channel amps. In fact, there are actually a few benefits you’ll get using one 4 channel amp instead of 2 stereo ones to power your front and rear speakers.