How do you calibrate a mechanical speedometer?
Press and hold the calibration button located on the speedometer, start the vehicle, and then release the button. Press that button again and then take the test drive. Once you have driven the distance needed, press the button once more and the speedometer will calibrate itself to accommodate the new tire size.
What makes a Harley Davidson Road King look new?
Some new gauges or a new Harley-Davidson Road King dash insert will make your Road King look like a brand new bike. Our huge selection of Harley-Davidson Road King dash & speedometers come in a range of styles and finishes to fit the overall design of your bike.
What to do if your speedometer stops working?
If your speedometer has stopped working, or you are upgrading to a newer model, changing it is a straightforward procedure if you have the right tools and know what to expect. Always check with a mechanic if you run into any problems, or there is something you don’t understand. Remove the negative battery cable from the battery.
How do you put the speedometer in the gasket?
Feed the speedometer into the gasket from the top side of the console. Lubricate the gasket, if needed. Make sure the speedometer fits against the gasket tightly, with no drift. Turn the console over. Put the lock ring over the back of the speedometer, making sure to align the two slots with the console bosses.
How do you remove lock ring from speedometer?
Place the instrument console gently on top of the clean towel, upside-down. Remove the speedometer connector at the back of the speedometer. Carefully lift the three latches on the interior of the lock ring upward. This will release the lock ring from the back of the speedometer. Invert the console and dislodge the speedometer from the top.
Some new gauges or a new Harley-Davidson Road King dash insert will make your Road King look like a brand new bike. Our huge selection of Harley-Davidson Road King dash & speedometers come in a range of styles and finishes to fit the overall design of your bike.
Why does my speedometer not work on my Fatboy?
I just bought a 04 Fatboy. The right turn signal don’t work, but the left works fine. The speedometer dose not work, when I turn the ignition on the needle wiggles a little, when I turn to Access the needle goes all the way around and points straight down.
Why does my Speedo not work on my Harley?
Speedo works when it wants but only at highway speeds and again randomly. Now blinkers are starting too work intermittently. Any ideas? Don’t believe both switches would go at same time, Short maybe or relay. Not sure and I would appreciate any ideas. Might be a failing Harley speed sensor. Remove the sensor and see if it needs to be cleaned.
What should I do if my speed sensor is bad?
Your speed sensor reports to your module, information, that is used for signal cancellation based on distance/speed. Check your speedo head for stored diagnostic trouble codes. If your problem is not a bad speed sensor, it may be a bad TSSM (turn signal security module ).