How do you remove clutch cable from motorcycle?
To remove the motorcycle clutch cable, take off any brackets still holding it in place and pull it free. Before you begin the installation of the new motorcycle clutch cable, lubricate it thoroughly then tighten the adjuster in the middle of the cable. Begin by working at the clutch plate end.
How do you adjust the clutch on a BMW?
Put a piece of duct tape on the middle like a flag, write “BMW Clutch Adjustment 201mm” and you got a free BMW Special Tool. 6) The second adjustment is made at the rear of the transmission, using the adjuster screw and locknut on the clutch arm.
How do you replace cable in airhead clutch?
To do this: 1) Replace cable, both ends now disconnected. 2) Loosen locknut at transmission lever, slacken adjuster screw several turns out. 3) Insert top end of cable through adjuster, into the lever slot, pushing it WAY in to the lever. Slip the greased barrel up onto the cable, and pull the cable back to engage the barrel on the cable.
What kind of lubricant does BMW clutch cable use?
1) The inner clutch cable does NOT get lubricant of any kind. The cable sheath has a Teflon sleeve that provides that function. (Non-OEM cables do not have that sheath, do whatever you want with them, they will wear out rapidly. Lube is a BAD thing for the inside of BMW cables, not a “what could it hurt?” thing.
How do you disconnect the clutch from the clutch?
You may be able to disconnect this by pushing the clutch operating lever away from the nipple with your fingers, then pulling the nipple out of the lever with pliers. But if the cable is too tight, you must slacken the cable tension. Look back along the cable and find the cable adjuster.
What should I do if my clutch cable is not renewing?
If there is still no improvement, you will have to remove the clutch cable and try lubricating it. Use modelling clay to make a funnel around the outer cable. If the cable is undamaged, it may simply require lubricating. You can sometimes oil the cable while it is in the car, but to do a really good job you need to remove the cable first.
How do you change the clutch cable on a Ford?
If the inner cable tries to move round as you remove the adjuster nut, hold the metal end of the cable with pliers until the adjuster undoes. The other connection, used extensively on Fords, has a nipple on the end of the cable that fits into a slot on the end of the clutch lever.
Put a piece of duct tape on the middle like a flag, write “BMW Clutch Adjustment 201mm” and you got a free BMW Special Tool. 6) The second adjustment is made at the rear of the transmission, using the adjuster screw and locknut on the clutch arm.