How do you change the fork seal on a Honda Goldwing?

How do you change the fork seal on a Honda Goldwing?

How to Replace Goldwing Fork Seals

1. Remove the lower leg drain plugs with a wrench and drain the forks.
2. Remove the large snap-ring at the top of the lower leg with a pair of inside snap-ring pliers.
3. Push the lower leg up onto the fork tubes, compressing the fork.
4. Remove the washer and old seal from the tube.

Can you remove the fork caps on a Honda Gold Wing?

Removal of the fork caps on the Honda Gold Wing forks is not only very dangerous, it is totally unnecessary unless you want to change your stock springs to aftermarket springs. Any time you remove the fork caps, you might as well consider it a two-man job to replace the caps.

How do you replace a fork seal on a motorcycle?

Use these steps to replace your fork seals. Prepare the motorcycle for maintenance. Loosen the 2 bolts that secure the fork legs to the frame and the caps upon each leg. Then loosen the brake caliper bolts and the whole front axle of the bike. Put the bike in gear and chock the rear wheel. Raise the front wheel off the ground as far as needed.

How to change fork oil on 2002 GL1800?

Torx socket used to remove left caliper. I used a bungee to tie support the caliper once removed. Removing right caliper with 12mm socket. Removing the axle bolt. Loosening axle clamp bolts. Notice caliper is supported with bungee to reduce stress on brake lines. Remove the axle, then just roll the wheel out.

What to use to replace Fork seal on 1983 GL 1100?

The GL1200 fork seal replacement is similar to the 1983 GL 1100 models with the following exceptions: Wrap some Scotch® brand Magic Tape™ tightly around the retaining ring groove to prevent damage to the new fork seal when installing the seal.

What should I do about my Honda Goldwing Fork seal?

Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later. Honda 51490-MCH-C11 – SEAL SET, FR.

How do you change the seal on a fork?

Disassemble the fork and remove the old fork seal. To prepare the fork for the new seal, rub away all rust and imperfections with an oil-soaked cloth. Then, put the new seal over the stanchion and tap the seal down with a seal driver.

The GL1200 fork seal replacement is similar to the 1983 GL 1100 models with the following exceptions: Wrap some Scotch® brand Magic Tape™ tightly around the retaining ring groove to prevent damage to the new fork seal when installing the seal.

What do you need to remove gold wings?

For the 1980-1987 Gold Wings, you’ll need a set of good strong snap ring pliers, preferably ones with a 90-degree angle, to remove the snap ring after you pry the dust boot up with a screwdriver. Clamp the fork slider in a vise, and remove the socket head bolt from the bottom of the fork.