When did the Polaris speedometer first come out?
There are at least two versions of speedometers used in the late 1990’s and early 2000s – the one that, inside, looks like Figure 4 with “through-hole” components and a slightly newer version that largely uses surface-mount components.
What does it mean when the VSC indicator light stops flashing?
The indicator light stops flashing after the registered key has been inserted into the engine switch to indicate that the system has been canceled. Depending on the vehicle, a buzzer (intermittent) may sound to indicate that VSC is operating.
Where is the turn signal module on a Street Glide?
Jonathan, sounds like you have a bad turn signal module. You will find this module between the fuel tanks, beneath your dash area. Thanks, and good luck Similar Question Been enjoying the videos and tips I have a 2008 Street glide with 90K miles on it. I always took it to the dealer until I found your website and got the premium membership.
What causes a constant on condition on a Speedo?
You can search for codes in your speedo head. The wrong bulb will cause a constant on condition as well. I bought a used soft tail springer that the previous owner had put an AutoZone bulb in one of the rear turn signals. The correct H-D bulb with the correct resistance fixed the issue cheaper than a module.
Why is my speedometer bouncing on my 96 dually?
My speedo is bouncing on my 96 dually powerstroke, they replaced the sensor on top of the rear end housing today as it went bad and transmission would not shift. Now all works great except speedo needle bounces around, where do I look to fix?
Why is the speedometer not working on my Ford PowerStroke?
About a month ago The #8 fuse blew, causing the speedometer to stop working along with the trans (VSS). I didn’t have time to look into it so I brought it to a shop. When I got it back the mech. said that he replaced the vehicle speed sensor and the fuse. ( $160.00, what a crook ).
Is there a trans on a Ford Speedo?
No sensor on the trans for the speedo, only the VSS. Carefully check the wiring between the VSS and the front of the truck for worn wires, specifically the twisted pair of wires going to the VSS that run all the way to the front of the truck. Also check the grounds as mentioned.