How to clean a Honda TRX 350 carb?
Please try again later. Your Honda TRX 350 carb clean starts with getting the carburetor out of the machine. Then, John uses a rebuild kit to replace the carburetor jets on our Honda Rancher. Our machine was having trouble idling, and as we disassemble the carburetor John uncovers the problem.
How do you replace a carburetor on a Honda rancher 350?
Replace the float inlet needle and spring provided in the carburetor kit. Use pliers to re-attach the float to the carburetor by pressing in the float pin. Remove the old gasket from the float bowl assembly and replace it with the new gasket provided in the kit.
How to troubleshoot a carburetor on an ATV?
Then turn the screw back to the baseline adjustment. Start the engine. With the engine running, turn the screw in, or clockwise. Make 1/4 turns until you notice the engine speed drop. Then turn it counterclockwise until the speed goes back up. Work for a while until you feel you’ve found the “sweet spot.”
What should I do if my carburetor is not working?
There are several basic troubleshooting tactics you can use to figure out what the problem is without wasting money or unnecessary trips to the garage. A carburetor is the section in a vehicle’s engine where the fuel is transformed into a vapor and mixed with air in order to be ignited in the vehicle cylinders.
Replace the float inlet needle and spring provided in the carburetor kit. Use pliers to re-attach the float to the carburetor by pressing in the float pin. Remove the old gasket from the float bowl assembly and replace it with the new gasket provided in the kit.
Where is air mixture screw on Honda carburetor?
The air/mixture screw will be on the front/bottom side of the carb on the outside of the bowl. Depending on the model 2-2 1/2 turns out from lightly seated will get you very close on that one. I can help and will be here for a while but on the inside of the bowl there is no screw with a spring.
How to set up the carburetor in a Honda?
And also you must have the piston at top dead center on the ignition stroke. Some guys use a screw driver in the spark plug hole and turn the motor over to find it or there should be a plug on the side of the motor you can take out and turn the motor over until you can see a “T” on the flywheel. Hope this info helps you get it back on the trail.
How do you remove throttle cable from Honda rancher 350?
Use a Phillips screwdriver to remove the screw that secures the black cover on the right side of the carburetor. Twist the spring-loaded mechanism located underneath the black cover that was just removed in the previous step in order to loosen and slip the throttle cable out of the inside of the carburetor.