What to do if your spark plug is bad?
Check the fuel system and/or stark timing. Weak sparks are orange or red and may be hard to see in daylight. If you did not see a spark, remove the coil wire from the distributor cap. Attach the spark tester to the distributor end of the coil wire. Crack the engine and check for a good spark at the spark tester.
How do you remove a spark plug wire?
First locate the spark plug wire which you would like to remove. Ensure you are able to gain access to the boot of the spark plug wire. Do not pull the wire portion as you can damage the wire which in turn will require a replacement. Grab firmly onto the spark plug wire boot, then twist in either direction and pull off simultaneously.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
Why does my spark plug wire keep jumping?
Attach the test light to a good engine ground. With the engine running, move the test light along the length of each spark plug wire. If a spark jumps from a plug wire to the test light at any point, this is an indication that the insulation has broken down, and the spark plug wire should be replaced.
How do you remove a stuck spark plug?
When this happens, you’ll need to know how to remove stuck spark plug wires. Spray a small amount of WD-40 around the edge of the spark plug wire. Make sure you get the lubricant on and around the surface where the plug wire meets the valve cover or the distributor cap (depending on which end you are trying to remove).
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
How are spark plugs supposed to work on a BMW?
When you slide a plug wire end like this over the bare threaded tip of the spark plug, you can feel that clip as it slides down over the ridges of the threads, leaving no doubt that you have it on. The original BMW 2002 plug wire ends are designed to accept the bare threaded post. Note the little clip on the hole. Rob Siegel
Do you need to replace a spark plug wire?
Although procedures for coil packs which are directly mounted on the spark plug may vary between makes and models. It is very important to take care when removing a spark plug wire as it can be easily damaged, therefore requiring a replacement. Replacements can be expensive, especially if they are only available in a set.