How to install a crane single fire ignition coil?
CAUTION: READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. INTRODUCTION The Crane Cams Single Fire Ignition Coil part number 8-3001 is intended for Harley-Davidson® applica- tions with aftermarket single fire ignitions such as the Crane HI-4 series that require a 3 ohm resistance coil.
What is part number for single fire ignition coil?
SINGLE FIRE IGNITION COIL Part Number 8-3001 WARNING: Do not perform any work or disconnect any part of the ignition system without first disconnecting the battery ground cable. WARNING: Do not come into contact with the coil primary wires or the sec- ondary plug wires while the engine is running.
Can a single fire ignition be used on a dual fire?
Using a cam sensor would be the most reliable way to phase a single fire ignition to a crank. Hoople is absolutely correct in his points about the stock dual fire (or wasted spark). Now he’s got a TC, but at least on a carbed Evo the conversion to single fire is easy: You’ve got your cam sensor in the nose cone.
What does dual fire mean on a Harley Davidson?
Having dual fire means there will be a spark firing on valve overlap (wasted spark) as well as the compression stroke. Normally that is not a problem with most cylinder set-ups. But with Harley’s there “can” be a problem if your using long duration cams.
CAUTION: READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. INTRODUCTION The Crane Cams Single Fire Ignition Coil part number 8-3001 is intended for Harley-Davidson® applica- tions with aftermarket single fire ignitions such as the Crane HI-4 series that require a 3 ohm resistance coil.
How to install the ignition coil on a Dyna s?
Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine. Install the bolt and tighten. Ensure that the rotor is still free to rotate. 7. Remove the wire that connected the points and ignition coil. 8.
How to install advance Assembly on Dyna’s engine?
Push the rotor down until it engages the weights on the advance assembly [it will only go on one way}. Ensure that the rotor rotates freefy·on the shaft as the advance weights move out and back. · 6. Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine.
Is the coil OK on a Harley Davidson?
My thought is that the coil is Ok because its now firing from the other tower looking at the ignition it is a Crane HI-4 single fire race Ignition with adjustment on it. I am hoping that is not the problem because its very $$$$$$$