Can you use premium gas in Polaris Ranger?
Most Polaris Off-Road Vehicles require unleaded gasoline with a minimum pump octane number of 87. Octane in excess of 87 will not damage the engine but typically will not result in performance gains. The exceptions to that rule are RZR Turbo and Pro XP models. They require unleaded fuel with an octane number of 91.
What type of oil does a Polaris Ranger use?
Includes everything you need to change your oil: 2.5 Quarts of PS-4 Full Synthetic 5W-50 Engine Oil. 1 Polaris Oil Filter, PN 2540086.
What kind of gas do RZRS use?
What Fuel Do I Need? RZR Turbos take 91 octane fuel. All other Polaris vehicles take 87. Those are Polaris’ fuel recommendations.
What kind of fuel filter does Polaris Ranger use?
If the filter has been soaked with fuel or oil it must be replaced. Fuel Filter Breather Filter The RANGER 4×4 500 EFI Engine uses a non-serviceable, high- Cover Seal volume, high-pressure, 60-micron internal fuel pump filter and an internal 10-micron filter located before the pump regulator.
How big is the engine on a Polaris Ranger?
3.818:1 Engine Displacement 499 cc Shift Type In Line Shift – H / L / N / R Trans. Oil Requirements Polaris AGL Gearcase Lube Number of Cylinders Belt 3211077 Bore & Stroke (mm) 92 x 75 mm Drive Belt Deflection 1.125”… 2007 RANGER 4X4 EFI R07RH50AF,AR,AT 9920635 9920905 NOTE: When ordering service parts be sure to use the correct parts manual.
How to fill a Polaris Ranger 60 / 40 Reservoir?
Polaris Premium 60/40 is already premixed and ready to use. Do Remove fill plug. not dilute with water. Fill Plug 40 ft. NOTE: Use of a non-standard pressure cap will not Fill reservoir to upper mark with Polaris Premium 60/40 allow the recovery system to function properly.
Where is the drain plug on a Polaris Ranger 500?
Fill Plug 10 ft. lbs (14 Nm) Remove gearcase drain plug (B) (11 mm) located on the Fill with the recommended fluid amount (5 oz.) or to the bottom of the gearcase and drain oil. Clean and reinstall the drain plug with a new sealing washer system. and tighten to 30-45 in. lbs. (3-5 Nm).
What kind of oil do I need for a Polaris Ranger 500?
The recommended oil is Polaris PS-4 Full Synthetic, which is part number 2876245 for 1 gallon and part number 2876244 for 1 quart. Polaris Oil Change Kits come with the correct amount of oil for your vehicle. The oil change kit for a RANGER 500 is part number 2202166. Note: Do not overfill.
What is the oil filter number on a Ranger 500?
The oil filter for a RANGER 500 is part number 2540086. 16. Install a new sealing washer on the drain plug. The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches.
Where do you change the oil in a Polaris Ranger?
The crankcase drain plug is located on the bottom of the crankcase. Access the drain plug from the bottom of the vehicle. To change the oil and filter, do the following: 1. Position the vehicle on a level surface in a well-ventilated area. 2. Place the transmission in PARK. 3. Start the engine. Allow it to warm up at idle for 2 to 3 minutes. 4.