How do you lower a headlight beam?
Pull the car as close to the wall as possible and turn on your lights. This way, you’ll find the centers of the low-beam headlights. Mark both spots with a single piece of horizontal tape running through the middle. Make the vertical tape marker about two feet long, again running through the center of the low-beams.
How do you turn off the high beam on a Toyota rav4?
With the headlights on, push the lever away from you to turn on the high beams. Pull the lever toward you to the center position to turn the high beams off.
How do you adjust the headlight aim on a Toyota RAV4?
Adjust the horizontal headlight aim into the specified range by turning aiming screw b with a screwdriver. Perform lo beam aim adjustment. If the screw is tightened too much, loosen it and then retighten it so that the final turn of the screw is in the clockwise direction. Use the same procedures for the rh and lh sides.
Is there a way to adjust the headlight on a Toyota?
Each Toyota vehicle features one of two kinds of processes for adjusting the headlight: one that allows you to adjust the low and high beams separately, and one that resuires you to adjust the low and high beams at the same time. The Camry and Solara, for example, feature headlights that adjust both…
Where is the light control switch on a Toyota RAV4?
Description When the light control switch, located on the headlight dimmer switch, is turned to the tail position, the taillight relay (marking: t-lp) turns on to illuminate the front side marker Components Removal Hint: Use the same procedures for the rh and lh sides.
How do you adjust the Lo beam aim?
Perform lo beam aim adjustment. The headlight aim moves down when turning the aiming screw clockwise, and moves up when turning the aiming screw counterclockwise.
How do you install a headlight on a Toyota RAV4?
Turn the bulb/socket unit in the direction indicated by the arrow to install it. Insert the bulb into the headlight. Turn the bulb in the direction indicated by the arrow to install it. Insert the bulb into the headlight. Turn the bulb in the direction indicated by the arrow to install it. Insert the bulb into the headlight.
Description When the light control switch, located on the headlight dimmer switch, is turned to the tail position, the taillight relay (marking: t-lp) turns on to illuminate the front side marker Components Removal Hint: Use the same procedures for the rh and lh sides.
Where are the base lines on a Toyota RAV4?
Stand the screen perpendicular to the ground. Align the v line on the screen with the center of the vehicle. Draw base lines (h line and v lh, v rh lines) on the screen as shown in the illustration. The base lines differ for ”lo beam inspection” and ”hi beam inspection”.
How do you adjust the beam of a headlight?
Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.