What oil does a Street Glide take?
10W-40 Harley-Davidson Street Glide Engine Oil.
How much engine oil does a 2008 Street Glide take?
About 3.5 quarts is the most you’ll ever need. Oil reading should be 1/2 way between the add/full marks on the dipstick (hot).
How much oil does Harley primary hold?
Fill the primary with oil Harley Davidson Softails require one quart of primary fluid. Be sure to check your owner’s manual or the AMSOIL Product Guide for the correct primary oil capacity for your bike.
Is synthetic oil good for Air-Cooled engines?
Since synthetic oil has better heat transfer qualities than dino oil, your internal engine temperatures will be lower. The wider range of temperatures that synthetic oil can withstand is well suited for the air-cooled VW engine.
How do you change the oil in a FLHX?
Fill the new oil filter with fresh motor oil and spread a thin coat of oil around the filter’s mating surface. Screw the oil filter into place by hand until it is seated against the motor.
Where does the oil drain go on a Milwaukee 8 engine?
The Milwaukee 8 engine oil drains from the front of the oil pan. The transmission oil drains from the bottom of the oil pan. The primary oil drain plug is in the inner primary case.
How do you do an oil change on a Harley Davidson?
You may want to use a torque wrench to tighten the plugs 14 to 21 feet (4.3 to 6.4 m)-lb; otherwise, tighten until the plugs are fully seated and not stripped. Remove the oil filter. Place your drain pan under the front end of the engine.
What are the specs of a Harley Davidson FLHX?
Harley-Davidson FLHX Street Glide Specs. In this version sold from year 2008 , the dry weight is 339.7 kg (749.0 pounds) and it is equiped with a V2, four-stroke motor. The engine produces a maximum peak output power of and a maximum torque of 125.56 Nm (12.8 kgf-m or 92.6 ft.lbs) @ 3500 RPM .
Fill the new oil filter with fresh motor oil and spread a thin coat of oil around the filter’s mating surface. Screw the oil filter into place by hand until it is seated against the motor.
You may want to use a torque wrench to tighten the plugs 14 to 21 feet (4.3 to 6.4 m)-lb; otherwise, tighten until the plugs are fully seated and not stripped. Remove the oil filter. Place your drain pan under the front end of the engine.
How much oil do you put in a Harley Davidson engine?
Fill the engine oil tank. The engine oil capacity is 3 quarts (2,800 ml; 100 imp fl oz). Most likely there is still oil left over in the sump, so fill it with 2 quarts (1,900 ml; 67 imp fl oz) and check the dip stick. Add oil until the oil level is between the low and high indicators on the dip stick.