What causes a motorcycle rectifier to go bad?

What causes a motorcycle rectifier to go bad?

Things like poor grounding, a loose or weak battery, and a worn battery connection can all lead to regulator rectifier failure.

What’s the problem with the Yamaha Star Venture?

Synthetic oils are much thicker than regular oils and do a better job of reducing motorcycle noise, and riders say that Yamalube obtains the best results for killing the Venture’s whine. 2. Bike May Overheat An enormous 113 cubic-inch V-Twin engine powers the Star Venture/Eluder motorcycles.

What should the voltage be on a Yamaha Venturer?

Set your meter to read AC (NOT DC) voltage on the 100+ volt scale. Start the engine and read each pair of terminals in the same order as you did above, 1~2, 1~3, 2~3. At normal idle speed, voltage should be around 20~25 volts AC on each pair.

What causes false test results on Yamaha Venture?

A weak or defective battery may cause false test results. Have the battery tested or replaced if it will not achieve a full charge from a battery charger. With a fully charged battery, start engine, turn off all electrical accessories. Read battery charging voltage as engine speed is increased to 5000 rpm.

Where is the stator coil on a Yamaha Venturer?

The stator coil is mounted stationary to the engine cover and is surrounded by the rotor magnets. When the engine is running, the spinning magnets around the stator coil create an AC voltage within the windings of the stator.

How big is the engine on a Yamaha Star Venture?

An enormous 113 cubic-inch V-Twin engine powers the Star Venture/Eluder motorcycles. As such, some excess engine heat is to be expected, especially since this bike is air-cooled. Unlike water-cooled engines, air-cooled engines depend on moving air to cool the engine. This means lesser components (no radiator, water jackets, etc.) and lower cost.

Set your meter to read AC (NOT DC) voltage on the 100+ volt scale. Start the engine and read each pair of terminals in the same order as you did above, 1~2, 1~3, 2~3. At normal idle speed, voltage should be around 20~25 volts AC on each pair.

What causes a Yamaha Star venture to stall?

Engine stalls for no reason: A faulty fuel pump will restrict fuel flow to the engine and will increase the chances of the engine stalling. Bike starts to overheat: A fuel-starved engine will eventually run lean, which will inevitably lead to overheating.

A weak or defective battery may cause false test results. Have the battery tested or replaced if it will not achieve a full charge from a battery charger. With a fully charged battery, start engine, turn off all electrical accessories. Read battery charging voltage as engine speed is increased to 5000 rpm.