Where is the front brake light switch on a Harley Davidson?
Where Is It? The switch is located in your right side, lower switch housing. To remove the switch, you will have to remove your front master cylinder and your throttle grip (throttle cables can stay with the housing). Unscrew and remove the right turn signal switch and cut any necessary tie wraps.
How do you replace a brake light switch on a Harley?
Unscrew and remove the right turn signal switch and cut any necessary tie wraps. Now you can remove the brake light switch shim (on most models) and remove the damaged switch. When removing the damaged switch, cut the wires at the switch, leaving you the most wire possible to work with.
How to replace the brake light on your car?
How to Replace a Brake Light Switch. Step 1 – Find the Brake Light Switch. The brake light switch is often found in the same location on all vehicles. You will need to open the driver Step 2 – Access the Brake Light Switch. Step 3 – Remove the Brake Light Switch. Step 4 – Replace the Brake Light …
Why does my brake light not turn on?
When the brake pedal is pressed, the switch signals the brake light to turn on. It is a fairly simple switch that is powered by a single electrical cable. The brake light switch can fail over time and, when that occurs, the brake lights will not switch on.
What kind of driver do I need for front brake light switch?
Remove the two screws that secure the handlebar clamp to the front brake master cylinder housing, with a Torx T-27 driver. Disassemble the right switch housing by removing two screws, with a Torx T-25 driver.
Where is the brake light switch on a Harley Davidson?
After assembly, the shim gets removed and the lever’s contact tab will rest against the switch all of the time, except when the front brake is applied. The front brake light switch has changed very little over the years and makes how to replace a brake light switch on a Harley fairly straightforward.
How can I Fix my brake light switch?
JB weld, a dab on the tab about 1/16″ fixed the problem completely, a very inexpensive and effective fix. Now I don’t get the little red lite on my speedo, and the brake lite functions the way it is supposed to.
What is part number for rear brake light?
The Front brake switch didn’t activate the rear brake light, I ordered a sensor from Harley ( part number 72001 – 69B ) and installed it. This is the part number for a rear brake light sensor to fit a 1984 FXWG wide glide shovel ) Check you have the right part number for your bike before ordering. Loading…
What does it mean when your brake light is stuck?
A majority of the time, the brake light is actually stuck on. This, most typically, is an indication that your front brake light switch is misaligned or broken. There are a few common ways a front brake switch gets damaged.