What should the pulser coil output be on a CDI?
Check the pulser coil output. It’s job is to tell the cdi when to fire the energy stored in the capacitor. Dis- connect the white / red trace wire and connect the meter leads to this wire and the ground wire. You should get a pulsating 4 to 5 volts AC. (ps, an analog meter is best for this test)
How much torque does a pulsar DTSi have?
Net Torque Starting Transmission Spark Plug 4 stroke, Air Cooled 165CC 60 x 58.4 9.3 SOHC psat 3000 rpm 4.22 at 6000 m 5 Speed Single Ignition Single spark Single spark Ignition Ignition
Which is HT ignition coil for Bajaj Pulsar 220F?
Bajaj Genuine HT Ignition Coil & CDI Unit for Bajaj Pulsar 220F with 220cc DTSi Engine.
How does a CDI pulse transformer ignition system work?
In a CDI ignition system,a storage capacitor is charged to a high voltage (a few hundred volts) by the flywheel charging coil and, at the proper moment quickly discharged into the primary winding of the ignition coil,which is actually a stepup pulse-transformer.
Check the pulser coil output. It’s job is to tell the cdi when to fire the energy stored in the capacitor. Dis- connect the white / red trace wire and connect the meter leads to this wire and the ground wire. You should get a pulsating 4 to 5 volts AC. (ps, an analog meter is best for this test)
Where does the voltage for a CDI come from?
The input to the CDI unit is derived from two sources of the alternator. One source is a low voltage around 12 volts while the other input is taken from the relatively high voltage tap of the alternator, generating around a 100 volts.
How does a capacitive discharge ignition ( CDI ) circuit work?
The basic working of a CDI unit is executed through the following steps: Two voltage inputs are fed to the electronic CDI system, one is high voltage from the alternator in the range of 100 V to 200 V AC, other is a low pulse voltage from a pickup coil in the range of 10 V to 12 V AC.
How many volts should I have in my starter?
You should have 30 to 50 volts AC depending on how good a battery and starter you have. 2. Check the pulser coil output. It’s job is to tell the cdi when to fire the energy stored in the capacitor. Dis- connect the white / red trace wire and connect the meter leads to this wire and the ground wire.